4.08 Gear Install (7AT) Review

blumango · 10-24-2013, 11:18 PM

Quote:

Originally Posted by 1slow370

you will need a couple shims for the side to side unless you get lucky, but you shouldn't have to move the pinion so you can leave the crush spacer and seals and front bearings and shims alone. You will also want to replace the ring gear carrier bearings any time you change the center section out. so you need the ring gear carrier bearings, and maybe shims any time you install a new lsd into a pumpkin.

Hi,

Thanks for your reply. I also seen some mention about an install kit for the gears, may I know where I can find this kit?

So to summarize, if I want to go 4:08 on my 7AT + Quaife I will need:

1) Ring Gear Bearing (Could you kindly advise part numbers?)

2) 4:08 Gears From Z1Motorsports

3) Install Kit (Kindly advise where I can get this kit from)

4) Pumpkin (Can I use my existing stock pumpkin??)

5) Shims

Is that all?

Thanks!

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Akuma intake install/review	FPenvy	Intake/Exhaust	15	11-25-2012 03:33 PM
ARK exhaust install and review	sofa_king	Intake/Exhaust	16	02-24-2012 11:15 AM
Berk CBE and HFC Install and Review	joshs09slvrZ	Intake/Exhaust	42	09-20-2011 05:28 AM
New Top Gear Review	fuzzywuzzy	Nissan 370Z General Discussions	28	08-25-2011 09:22 AM
NIssan 370Z Top Gear Australia Review (Full Video Inside)	AK370Z	Nissan 370Z Photos / Spyshots / Video / Media Gallery	24	06-18-2009 01:16 PM