|
Pics look horrible, I looked at them again, and you can't really make out the hole. However I did finally barrow a friends OBD2, and I popped co PO171 I
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
02-04-2011, 09:43 PM
|
#10 (permalink) |
|
Base Member
Join Date: May 2009
Location: Redondo Beach
Posts: 167
Drives: 09 370Z RED M6
Rep Power: 266   |
Pics look horrible, I looked at them again, and you can't really make out the hole. However I did finally barrow a friends OBD2, and I popped co PO171 I guess it means, Fuel Trim Lean (Bank 1). I did some research on the code, and it said I could have a bad MAF, so I checked them and the are spotless. I had a bad MAF on a much older car, and the car would barely idle when it was bad, so I don't think that is the problem. It also said I could have clogged injectors, so I ran some fuel injector cleaner through. So far after I reset the light, it hasn't come back on. I will see tomorrow after I drive to Vegas....
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Z1 Motorsports JDM Fog Light Light Installation Kit (Starting @ $18.00 w/ out Light) | Dustin@Z1 | Body Interior/Exterior | 4 | 11-04-2016 05:16 AM |
| Anyone installed the rear fog light as a brake light on a roadster? | Lee123 | DIY Section (Do-It-Yourself) | 4 | 05-01-2010 07:53 PM |
| Local 370z needed for smoked tail light and head light fitting | dantegts | Southern California Region | 11 | 04-07-2010 07:55 PM |
| Question about fog light for the guys with the factory fog light from Canada/Europe | Jowe | Exterior & Interior | 28 | 09-27-2009 12:50 PM |
| smoked tail light and head light volunteer covina, ca area | dantegts | Exterior & Interior | 0 | 08-29-2009 12:33 PM |
Threaded Mode
