Random engine stalling and choking issue - no DTCs, Service Engine light on

2011 Nismo#91

Generic OBD 2 scan tools won't always be able to read all codes. With that said if you have fuel and you have air the last thing is to check the spark. Coils and plugs. See if you can take it somewhere with a good scanner tool, could save you some time and money.

__________________
GTR TT 493Whp/431lbft, Ecutek, Southbend 6puck,Quaife, RPM RollBar 4Point, R888R, JRZ RSPro F(10R/10C) R(10R/6C) 1000f500r inlbs+150inlbs Tender, SPL everywhere.Full Specs

Sarithis

Apologies for reviving this thread, but I've finally identified the issue. Based on your suggestion, I replaced the spark plugs, as they were due for replacement anyway, and inspected the coils. Unfortunately, it didn't fix the problem, and I dont' have access to a professional scanner, but it wasn't severe enough for me to act immediately, so I chose to live with it for a while.
Starting around November / December, the frequency of stalling increased significantly. I decided to replace the fuel pump and ordered a new DeatschWerks 340lph along with an OEM harness. When I removed the old one, it turned out that the pump was completely loose within the harness body. Nissan's design for installing a fuel pump is incompatible with many aftermarket pumps due to their larger size, so the previous owner had to cut the lock-in mechanism off the harness to make the installation work. Unfortunately, they failed to create a secure alternative, or if they did, it clearly wasn't effective.

My theory is that when the pump started drawing fuel, the resulting vacuum caused it to stick to the bottom of the housing through the filter. This would explain why the issue often occurred on rough terrain, where vibrations likely caused the pump to shift and get stuck temporarily. Curiously, this issue cannot occur with the OEM pump, even if it detaches from the lock mechanism. The original particle filter includes a plastic component that maintains a gap between the bottom of the filter net and the pump nozzle, preventing it from sticking to the housing. To be clear, I'm not sure if this net is even supposed to act as a filter or just a fuel "collector", but that's not important.

I resolved the issue by installing the new pump and harness, using fuel-resistant adhesive to secure it in place. Since then, the problem has been completely eliminated.

Some manufacturers include an elastic sleeve designed to create enough friction between the pump and the housing to prevent it from sliding down. However, considering the strong vacuum at the bottom of the pump, I'd recommend adding a strong fuel-resistant adhesive or creating a proper lock-in mechanism that would provide a more reliable and long-term solution.

Here's how it looked: https://imgur.com/a/0mfE5xo