|
Managed to get it off. I cut through the flange on the bolt and could remove the bolt with my fingers. I then had to grind some flat spots on
|
|||||||
16Likes
|
|
LinkBack | Thread Tools | Display Modes |
07-31-2022, 07:24 AM
|
#10 (permalink) |
|
Base Member
Join Date: May 2022
Location: Perth, Australia
Posts: 5
Drives: 2009. Stock-no mods
Rep Power: 4  |
Managed to get it off.
I cut through the flange on the bolt and could remove the bolt with my fingers. I then had to grind some flat spots on the rear of the broken pulley for the fingers of my puller to grab on to. After that, it simply pulled off. Here’s the photos. I hope this helps someone else. C2A3B2CF-77BA-4873-AD18-4B8FDD36D922.jpeg 2194842E-36D8-448A-99F5-F29C1CBAA879.jpeg F58D7015-0E70-461F-BF7C-BF06BF45FF37.jpg 439DD09E-66E4-494B-A3AC-976D62114D95.jpg 4C1CA9D3-F394-4CED-AA01-7751F8AD0B46.jpeg 366D8386-2F76-4541-B926-AED975A1A401.jpg |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Crankshaft Pulley Install Help | ShadowJester6 | Engine & Drivetrain | 10 | 03-10-2021 10:47 PM |
| Crankshaft bolt removal after NST pulley failed | Rangerz | Engine & Drivetrain | 17 | 07-11-2015 07:49 AM |
| NST Pulley Install - Crankshaft bolt stuck? | Alstann | Engine & Drivetrain | 10 | 12-02-2012 06:28 PM |
| Crankshaft Pulley install question | cotizi | Engine & Drivetrain | 6 | 04-03-2011 09:33 PM |
| Stillen Under Drive Crankshaft Pulley | Musashi | Nissan 370Z General Discussions | 5 | 05-14-2009 06:28 PM |
Threaded Mode
