![]() |
I've been debating over OEM, EPS, and CZP gaskets. I've seen a few people say the OEM still has issues and EPS was better, but is also the most expensive.
|
|||||||
8Likes
|
|
LinkBack | Thread Tools | Display Modes |
|
|
#9 (permalink) |
|
Track Member
Join Date: May 2009
Location: A rock in a big pond
Posts: 681
Drives: 2009 370Z, 2012 M56
Rep Power: 3396 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
I've been debating over OEM, EPS, and CZP gaskets. I've seen a few people say the OEM still has issues and EPS was better, but is also the most expensive. However, I'm not too keen on the CZP gasket since I don't think that is steel reinforced.
I think I'm just going to spend the little bit extra to not have to do this job again.
__________________
CZP are lying thieves! |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OEM Fuel pump question | Patrickz34 | Engine & Drivetrain | 4 | 08-30-2018 09:47 PM |
| interior removal question | Zeetah | Nissan 370Z General Discussions | 2 | 07-09-2016 06:16 PM |
| Fuel pump question | TBatt | DIY Section (Do-It-Yourself) | 18 | 07-05-2016 02:45 PM |
| Fuel Pump voltage stabilizer (GTM) kit? question.. | snowsurfdirtx | Forced Induction | 1 | 03-08-2014 05:10 AM |
| Question about the DIY removal of steering wheel | Angel55 | Exterior & Interior | 3 | 07-01-2013 06:09 PM |