Need Advice! New Clutch Kit, P0335 Crank Sensor Code.

Originally Posted by shaks95

I removed the Z1 flywheel and installed the stock dual mass flywheel, because Z1 hasn’t been replying to any emails and I needed the car on the road.

So after driving 100km (60miles) and keeping the engine revs below 3k rpm, the factory dual mass decided to break/damage, according to my mechanic he said that the 6 puck clutch had too much force for the factory flywheel and damaged it along with my starter motor


Sent from my iPhone using Tapatalk

Originally Posted by Rusty

Originally Posted by -ZS-Carpenter

Maybe this is why Joe says to not use Z1 clutch kits with the CMAK

He told me it was a clearance issue with the shift fork but maybe there is more too it.

OP, Call Joe@ZSpeed