Coolerworx shifter

scope22

Anyone has any experience installing these? Z1 told that they would have to cut some of the bezzel, i'm guessing from the bottom to make space for the shifter, all pics show the bezzel intact from the top but nothing from the bottom. Installation instaructions that came with that shifter are for 350z

NorthStyle

If you've purchased one recently, you shouldn't have to cut or drill anything since I went through the trouble of helping Coolerworx develop a 370Z-specific plate (however, prior to this it was only drilling 4 holes for the 350Z plate we were being sent).

**If anyone that purchased one of the older versions with the 350Z plate haven't swapped to the correct version, I still have the prototype plate/spacers available to make it a direct fit without drilling.

Also, like andy_meng1024, I cut part of the stock rubber boot/seal and used it to remove some of the road noise.