|
I also installed my osgiken diff without any added shims. As long the gear mesh looks good you should be fine. I would think you’d run into problems if you
|
|||||||
4Likes
|
|
LinkBack | Thread Tools | Display Modes |
06-17-2022, 06:01 AM
|
#11 (permalink) |
|
Enthusiast Member
Join Date: Dec 2010
Location: new jersey
Posts: 452
Drives: 2011 MB 370Z NISMO
Rep Power: 1247   |
I also installed my osgiken diff without any added shims. As long the gear mesh looks good you should be fine. I would think you’d run into problems if you would be swapping out the final drive gear ratio. Just make sure you have new seals and new side bearings
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quaife differential install question | DEpointfive0 | Engine & Drivetrain | 8 | 06-12-2022 09:23 AM |
| Quaife differential install question | DEpointfive0 | Nissan 370Z General Discussions | 7 | 09-16-2015 01:46 PM |
| Differential flange question (Stub shaft) | chrischhorn | Engine & Drivetrain | 5 | 04-10-2013 07:34 PM |
| Rear Differential Question | jpit | Engine & Drivetrain | 8 | 12-23-2011 08:57 AM |
| Base 370z Differential Question | PRSMESA24 | Engine & Drivetrain | 20 | 06-06-2009 08:33 PM |
Threaded Mode
