Vibration after bushing and vlsd install

BGTV8 · 07-27-2017, 01:25 AM

The tailshaft is spigoted onto the flange on the nose of the diff.

Did you ensure there was no cr4p between the tailshaft flange and diff flange and they pulled down square.

Even a little bit of cr4p between the flanges will result in a vibration.

The other thing is whether all the bushes for diff mountings are snug - I dont recall whether there is a steel insert inside poly bush itself or not - if that was omitted and the diff can move on the bolt, you will get a clunk rather than a vibration though.

If have these and it certainly is noisier (a lot).

That is tailshaft side, driveshafts should also be snug and have no movement.

First things first, re-check all fasteners that were touched as first item of business

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[WTB] Factory VLSD or Qualife VLSD	ReflectingG0d	Parts for sale (Private Classifieds)	2	02-10-2015 10:38 PM
350z Whiteline Diff bushing install	go7roo7	DIY Section (Do-It-Yourself)	0	05-20-2014 07:39 AM
base model to vlsd install	iamgus_gus	Engine & Drivetrain	14	02-27-2014 09:52 AM
[FOR SALE] Driver side VLSD/6MT axle stub (needed for OS Giken LSD install)	clintfocus	Parts for sale (Private Classifieds)	50	11-26-2013 05:58 PM
Shifter Vibration/ Shift knob vibration	BlackCherryZ	Nissan 370Z General Discussions	31	01-16-2010 09:53 AM

07-27-2017, 01:25 AM	#5 (permalink)
BGTV8 A True Z Fanatic Join Date: Dec 2009 Location: 03350 Australia Posts: 1,516 Drives: 09 Nissan 370Z M6 Rep Power: 39975	The tailshaft is spigoted onto the flange on the nose of the diff. Did you ensure there was no cr4p between the tailshaft flange and diff flange and they pulled down square. Even a little bit of cr4p between the flanges will result in a vibration. The other thing is whether all the bushes for diff mountings are snug - I dont recall whether there is a steel insert inside poly bush itself or not - if that was omitted and the diff can move on the bolt, you will get a clunk rather than a vibration though. If have these and it certainly is noisier (a lot). That is tailshaft side, driveshafts should also be snug and have no movement. First things first, re-check all fasteners that were touched as first item of business