|
Originally Posted by Nismonerd If you're using AN 10 fittings, you'll need a 1 in wrench. Make sure the bolt holding your sandwich plate is torqued per your instructions, mine
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-26-2016, 06:56 PM
|
#7 (permalink) | |
|
Enthusiast Member
Join Date: Jun 2016
Location: NorCal
Posts: 259
Drives: 09 Z. 06 Zx636
Rep Power: 30   |
Quote:
Thank you. I hand tightened with my strength for the AN fittings then wrenched it one by one.. I tried to use alot of force; but not enough so that I will strip anything. Wish they had a TQ # for the AN fittings. I TQ the sandwich plate to the desired level per manual.. It was 25 i believe. It was hard to wrench down the second fitting due to space and size of my wrenches as well as me lying down for it lol. Sort of wished i could find a short hose with the AN fittings on both sides so i could have 2-3 inches attached to the sandwich then install the lines to it. But all is well for now. Went for a few spirited runs ~10 miles and checked again, no leaks. Everything is going to go back on Almost 100 degrees today, oil temp sits @ 190-200. Saw 210 for a breif moment Sent from my iPhone using Tapatalk |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '14 really need oilcooler? | FLUJOKE | Engine & Drivetrain | 4 | 04-04-2014 12:59 PM |
| Rattle noise!!! Not loud but loud enough to be annoying!! | Cam1379 | Nissan 370Z General Discussions | 2 | 12-16-2013 04:17 PM |
| Tech gurus Help Z1 oilcooler VS Mishimoto Oil Cooler | Zoren 370 | Exterior & Interior | 5 | 02-18-2013 04:22 PM |
| Loud ticking noise from engine | Synack | Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs | 191 | 03-01-2012 06:22 PM |
| oilcooler | Mrbiker | Forced Induction | 7 | 09-03-2011 01:32 PM |
3Likes
Threaded Mode
