09-26-2016, 05:54 PM
|
#6 (permalink)
|
|
Base Member
Join Date: Jan 2016
Location: North Alabama
Posts: 37
Drives: 2010 370z Nismo
Rep Power: 10
|
Quote:
Originally Posted by NRGz
Have you installed one? How did you manage to tighten up the fittings on the sandwich plate? I had a hard time tightening it down.. Do you know what size wrench it is? I was using a monkey/adjustable one and found it hard with the amount of room i had
Sent from my iPhone using Tapatalk
|
If you're using AN 10 fittings, you'll need a 1 in wrench. Make sure the bolt holding your sandwich plate is torqued per your instructions, mine was 20ft lbs. install the hose AN fitting that is hardest to get a wrench on first. Start it by hand getting as many turns as you can to ensure you're not cross threaded. Then use the wrench to snug it up. You may need to hold the sandwich plate with your other hand to keep it from rotating. Then install the other AN fitting by hand as you did the first. Use the wrench and hold the sandwich plate to keep it from rotating. If you've properly torqued the sandwich plate bolt, it should stay where you want it. You may be trying to over tighten the AN fittings.
|
|
|
Similar Threads
3Likes
Threaded Mode
