Installed new clutch and its slipping!!

BGTV8 · 08-18-2016, 06:09 AM

Clutch not clearanced correctly .... pressure plate is not providing sufficient clamping force against driven plate.

Does South Bend recommend dxd black billet flywheel ??

Alternative is the csc is partially pressuring the pressure plate (like you already have your foot partly on the clutch.

This needs measuring up.

Thrust race on csc needs to be free from pressure plate fingers with no pressure in the clutch line (eg: foot not on clutch).

I am not familiar with Z1 csc kit - is it concentric with the input shaft of gearbox ... if so, it needs adjustment to remove pre-load on the pressure plate.

If it is a fork-type, you should be able to adjust externally.

Anyone familair with the Z1 csc kit available to assist ....

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
clutch slipping during track days	cossie1600	Track / Autocross / Drifting / Dragstrip	34	12-02-2017 12:27 AM
Clutch problem after installed new Zspeed CSC	EVOR	Engine & Drivetrain	11	03-07-2016 12:13 AM
Help! Is my clutch slipping?	mastersapo	Engine & Drivetrain	3	11-30-2014 08:46 PM
Clutch slipping or srm?	cossie1600	Engine & Drivetrain	3	01-30-2014 09:31 AM
OEM Clutch Slipping on 1st gear?	innovate370	Engine & Drivetrain	3	08-24-2013 06:52 PM

08-18-2016, 06:09 AM	#2 (permalink)
BGTV8 A True Z Fanatic Join Date: Dec 2009 Location: 03350 Australia Posts: 1,516 Drives: 09 Nissan 370Z M6 Rep Power: 39974	Clutch not clearanced correctly .... pressure plate is not providing sufficient clamping force against driven plate. Does South Bend recommend dxd black billet flywheel ?? Alternative is the csc is partially pressuring the pressure plate (like you already have your foot partly on the clutch. This needs measuring up. Thrust race on csc needs to be free from pressure plate fingers with no pressure in the clutch line (eg: foot not on clutch). I am not familiar with Z1 csc kit - is it concentric with the input shaft of gearbox ... if so, it needs adjustment to remove pre-load on the pressure plate. If it is a fork-type, you should be able to adjust externally. Anyone familair with the Z1 csc kit available to assist ....