DIY: STILLEN G3 Intakes

bucketman · 03-28-2010, 08:21 PM

Here is the pics. Remove the plastic clip, then pullout the inner fender liner. Remove the 10mm bolt, then the squimish part, grab the bumper cover and give it a hard tug, the clips will pop right out. Of course this after you have removed all the other push pins and bolts.The other pics are of the cover over the strut bar, after removing the two push pins, just pry or yank up, there are a bunch of clips as you can see, just takes some muscle. Good luck.

kartman · 03-28-2010, 09:46 PM

Quote:

Originally Posted by bucketman

Here is the pics. Remove the plastic clip, then pullout the inner fender liner. Remove the 10mm bolt, then the squimish part, grab the bumper cover and give it a hard tug, the clips will pop right out. Of course this after you have removed all the other push pins and bolts.The other pics are of the cover over the strut bar, after removing the two push pins, just pry or yank up, there are a bunch of clips as you can see, just takes some muscle. Good luck.

Awesome... thanx so much... this looks OK to me... when you tug on the bumper to remove, where are the clips underneath? How many? Where should I be grabbing? Whole bumper in one tug or L-side then R-side?

I think I can figure it from here but any answers to the above might make it much less trial and error.

bucketman · 03-28-2010, 10:17 PM

The clips slip right into the fender,in between the light and outside. Grab the fender on the outside edge just below the fender and give a tug..pop. After you have everything else loose, do one side at a time. Be ready for the nose to be in your lap after you do the second side, its not heavy it just comes at you,. Good luck!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[WTB] Stillen Gen 3 Intakes	ShockWave	Parts for sale (Private Classifieds)	4	04-26-2012 10:18 PM
WTB: Stillen G3 Intakes or K&N Typhoon intakes!	gromano	Parts for sale (Private Classifieds)	5	07-15-2010 08:38 PM
Wtb - stillen exhaust / stillen intakes / berk cats	xbigb4ller69z	Wanted	0	03-24-2010 11:39 PM
FI 12" Exhaust - Stillen G3 Intakes - Stillen UD Pulley - GAINED 28kw or 37HP	bezzita	Australia/New Zealand	29	09-27-2009 12:53 PM
FI 12" Exhaust - Stillen G3 Intakes - Stillen UD Pulley - GAINED 28kw or 37HP	bezzita	Engine & Drivetrain	6	09-06-2009 05:20 PM

03-28-2010, 10:17 PM	#3 (permalink)
bucketman Enthusiast Member Join Date: Jun 2009 Location: Prairieville,LA Posts: 306 Drives: 09 Nismo 370Z MB Rep Power: 17	The clips slip right into the fender,in between the light and outside. Grab the fender on the outside edge just below the fender and give a tug..pop. After you have everything else loose, do one side at a time. Be ready for the nose to be in your lap after you do the second side, its not heavy it just comes at you,. Good luck!