|
Originally Posted by SAM@GTM Thanks for taking the time and posting your Input it is greatly appreciated FYI we did switch the 45" lines to 90 " let me know
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-10-2010, 10:38 AM
|
#12 (permalink) | |
|
Track Member
 
Join Date: Mar 2009
Location: Lithia, FL
Age: 52
Posts: 552
Drives: 09 Nissan 370z CS M6
Rep Power: 187   |
Quote:
The angle of the fittings from the engine force you to route the lines above the sway bar. While, I have seen them installed both ways (over and under the sway bar), I am wondering if that angle is putting tension on that portion of the line. I doubt it though.
__________________
Dynojet 285 HP/245 TQ (pre CBE)// Agency Power CBE // GTM Test Pipes // JWT Pop Chargers // B&M Short Shifter // Eibach Springs // Powder-coated Akebono's // Powder-coated Strut Bar // Black Chromed 19" Rays // // Redline Designs Graphics TipsZ journal Last edited by TipsZ; 03-10-2010 at 01:55 PM. |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Z1 Motorsports 25 row oil cooler install | falconfixer | DIY Section (Do-It-Yourself) | 5 | 05-30-2014 04:32 PM |
| Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler | Dustin@Z1 | Engine & Drivetrain | 158 | 03-10-2014 02:27 PM |
| Z1 Motorsports Thermostatic Sandwich Plate kit (For Nissan Motorsports Oil Cooler) | Dustin@Z1 | Drivetrain/Engine | 3 | 06-08-2012 11:10 AM |
| Z1 Motorsports Thermostatic Sandwich Plate kit (For Nissan Motorsports Oil Cooler) | Dustin@Z1 | Z1 Motorsports | 0 | 08-06-2010 11:26 AM |
Threaded Mode
