|
Forgot to add this earlier but here is the technique I used to get the nut off without destroying it. Before you even start to loosen the nut just take
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-06-2010, 10:17 AM
|
#11 (permalink) |
|
A True Z Fanatic
 
Join Date: Apr 2009
Location: SC
Posts: 2,464
Drives: 370Z
Rep Power: 545   |
Forgot to add this earlier but here is the technique I used to get the nut off without destroying it. Before you even start to loosen the nut just take your Dremel and cut a slot in the bolt. Then shove a flathead through a ratcheting wrench to hold the bolt while you ratchet off the nut. This method allows you to re-use both the nut and bolt if needed.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fog Lamp install with DIY harness question | wdkwang | Exterior & Interior | 10 | 03-02-2015 01:02 AM |
| Install of Stillen G3 Intakes complete - review, etc. | semtex | Intake/Exhaust | 83 | 06-23-2010 12:19 PM |
| Forged Performance: TEIN Flex Install 370Z Complete | Sharif@Forged | Brakes & Suspension | 37 | 02-19-2010 03:51 AM |
| Install complete ( Finally ) Item list, Cost, Time | 355890 | Audio & Video | 11 | 06-28-2009 11:14 PM |
13Likes
Threaded Mode
