DIY: Brake rotor replacement (front)

flashburn

Been beating the **** out of my rotor with a rubber mallet for like an hour, still won't budge. Sprayed some PB Blaster on it as well. Ugh.

__________________
Current Ride: 2012 Chevrolet Corvette Grand Sport Centennial Edition Carbon Flash 6M
Previous Ride: 2009 Nissan 370Z Sport Platinum Graphite 7AT

ChrisSlicks

That sucks. I had one old car that I was working on with a friend that wouldn't come off for anything. We tried torches, drills, 10lb sledge hammer, you name it. In the end the wheel bearing was toast so we just removed the wheel bearing and brake rotor as one unit.

You can try applying some heat from a torch (if you have it) around the face of the rotor but that only really works if you have a real torch (oxy). Another trick that works sometimes is to put the wheel back on over the studs and using your hands to jar the edge of the wheel causing a lever action on the rotor.

__________________
Hotchkis ARB | Stillen CAI | Art Pipes | Berk CBE | Stillen AP Racing Brakes | AE Performance Oil Cooler | BC Racing ER Coilovers | Doran Control Arms

MJB

What I did was grabbed both ends of the rotor by handle, and wiggle the crap out of it, then I would turn the rotor 1/4th of a turn and continued to wiggle it.. It came off after about 10min. Good luck.

icormba

Sorry it's a bit late, but the little screw that is on the front rotor can also be used to remove the rotor. Take the collar off the screw and use the 12 mm ratchet and tighten the screw... pop, the rotor will come right off no matter how seized it is.

ByThaBay

And here's a video to go along with this thread:

2008 G37 w/ akebono bbk front brake job

BudzZz

Thx man big help, i knew there must have been an easier way then beeating the hell out of the rotor lol

+Rep !!

__________________
2012 Subaru Sti Sedan **SOLD**** 09 370z 6MT MB Sports Pack // BC coilovers// SPC camber Kit // Forgestar F10// F.I. 12" Res Catback & Non-Res TP // Injen CAI // Shine Auto // Stillen // Evo-R ****SOLD**