|
Removing the Nissan plastics Gently pry the rain sensor cover off the screen. There are a couple of velvro-like clips that hold it on so don't worry about any scary
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-18-2010, 12:55 PM
|
#4 (permalink) |
|
Enthusiast Member
Join Date: Sep 2009
Location: England
Posts: 258
Drives: UK Yellow 370Z
Rep Power: 18  |
Removing the Nissan plastics
Gently pry the rain sensor cover off the screen. There are a couple of velvro-like clips that hold it on so don't worry about any scary noises when this is removed!   Pry the interior lights open like so (there are 4 clips holding each one on):  Unclip the centre section that holds the ambient light (your power supply for the mirror) and sensor:  The cables are quite short but the 2 devices unclip easily:  The Blue (+12v) and Yellow (GND) cables going to the ambient light are your power supply for the auto dimming mirror. The ambient light is only powered when the side lights are on. Do not power the mirror from the interior lights as these are permanently live and the mirror will drain your battery.
__________________
In the UK? Check out nissansportz.com - 350Z, GT-R, 370Z and more...
 2004 Sunset 350Z to 2009 Limited Edition Ultimate Yellow 370Z |
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Nissan Auto Dim rearview mirror | Jack370Z | Exterior & Interior | 3 | 10-11-2010 12:12 AM |
| AN fitting movement / rotation on Oil Cooler Lines? | TipsZ | Engine & Drivetrain | 26 | 03-12-2010 06:03 AM |
| Help test fitting HKS Oil Cap! | eXo5 | North East Region | 0 | 05-13-2009 01:57 PM |
| Auto-dimming rear view mirror - install? | alvinmathew88 | Exterior & Interior | 2 | 04-08-2009 09:53 PM |
| very concerned about fitting in the 370 | g35300mm | Nissan 370Z General Discussions | 10 | 02-23-2009 08:50 PM |
1Likes
Threaded Mode
