Coilovers

Z-Girl 12 · 10-13-2013, 03:34 PM

Quote:

Originally Posted by Alexwallace23

Did you have to get your tires tilted inward in order for them to clear the fenders when you dropped it?

I have 20mm spacers all around and I still remember you telling me to go with 25mm on the rear. I'm going to stick with the 20mm because the tires are right inline with the fenders.

20/25mm and no problems or fabrications needed. after initial setup my fronts were rubber the fender on turns but I had it dialed in as low as possible. after a few days had it raised and fenders are all in tact. i wanted the tires to stick out slightly so 20/25 was just right for what I was looking like.

1087 · 10-13-2013, 06:32 PM

Quote:

Originally Posted by alexwallace23

my friend that recommend the stance to me insists that i do not need chambering kits because the super sports have chamber plates installed. I'm assuming the + would also have this. So i'm going to go ahead and install just the coilovers sometime next week. Afterwards, i will get an alignment and if i run into any issues because of the stock suspension components then i will look into chamber kits. I will give an update after it's done.

camber and toe kit are necessary if you are going to lower the car.

Alexwallace23 · 02-02-2014, 10:53 PM

So I finally installed the coilovers and my friend that said that I would not need camber kits was wrong and all of you here are right. I did get Kinetics rear camber and traction kit just to be on the safe side and I am now about to buy a camber kit for the front since Stance only makes the front coilovers with built in camber plate for vehicles with McPherson type suspension. Yes I should have been able to figure this out prior to installing the coilovers but the same friend said it had the front camber plate.

The shop that did the install pretty much set it to the lowest. It did look great but I scraped the mid section of the exhaust pipe really hard while going into my own garage. So I had to raise it up about an inch. Once I get the front camber kit I will do another alignment and I should be able to get everything back to spec.

RICAN · 02-03-2014, 01:35 AM

pics!!....i want to see how low your car is!!

Alexwallace23 · 02-03-2014, 04:47 AM

You can look at my photo album to see it on the alignment lift. It's not the best pic but you can somewhat see how low it was. I will post pics showing the current height soon.

Quote:

Originally Posted by RICAN

pics!!....i want to see how low your car is!!

RICAN · 02-03-2014, 05:34 AM

ok thanks!!

synolimit · 02-03-2014, 06:54 AM

Jesus Christ, -5.0 rear? Shoot your friend.

Chuck33079 · 02-03-2014, 06:58 AM

I'd say it's about time to stop listening to that friend as far as car mods go.

Alexwallace23 · 02-03-2014, 08:06 AM

The rear has a camber kit. The guy that did the alignment said that's the best he could do with it being so low. I should be able to get everything in the green with the next alignment.

Quote:

Originally Posted by synolimit

Jesus Christ, -5.0 rear? Shoot your friend.

Chuck33079 · 02-03-2014, 08:09 AM

Wait- you have camber arms installed in the rear and can only get -5.0?

Alexwallace23 · 02-03-2014, 08:09 AM

Done.

Quote:

Originally Posted by Chuck33079

I'd say it's about time to stop listening to that friend as far as car mods go.

Alexwallace23 · 02-03-2014, 08:15 AM

Yes. The tires would have been right up against the fenders if the guy tried to get closer to zero. Does this not sound right to you? Should I find another shop to do my alignment?

Quote:

Originally Posted by Chuck33079

Wait- you have camber arms installed in the rear and can only get -5.0?

Chuck33079 · 02-03-2014, 08:18 AM

Are you running aftermarket wheels and tires? If you're on stock wheels and tires and he can't get the alignment right with camber arms and toe bolts installed, I'd try another place.

Alexwallace23 · 02-03-2014, 08:29 AM

I have stock wheels and tires. I also have 20mm spacers installed. I'm sure the camber would have been better if they were off.

Quote:

Originally Posted by Chuck33079

Are you running aftermarket wheels and tires? If you're on stock wheels and tires and he can't get the alignment right with camber arms and toe bolts installed, I'd try another place.

Sent from my iPad using Tapatalk HD

Chuck33079 · 02-03-2014, 08:32 AM

I can't see those spacers making that big of a difference in camber. I'd go try another alignment shop.

02-03-2014, 06:54 AM	#22 (permalink)
synolimit A True Z Fanatic Join Date: May 2013 Location: Columbus, OH Posts: 5,051 Drives: 2013 Silver 370z Rep Power: 3389	Jesus Christ, -5.0 rear? Shoot your friend. __________________ 13 370z-

02-03-2014, 06:58 AM	#23 (permalink)
Chuck33079 A True Z Fanatic Join Date: Nov 2011 Location: Houston Posts: 12,265 Drives: 2011 370ztt Rep Power: 29538	I'd say it's about time to stop listening to that friend as far as car mods go. __________________ 2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

02-03-2014, 08:09 AM	#25 (permalink)
Chuck33079 A True Z Fanatic Join Date: Nov 2011 Location: Houston Posts: 12,265 Drives: 2011 370ztt Rep Power: 29538	Wait- you have camber arms installed in the rear and can only get -5.0? __________________ 2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

02-03-2014, 08:18 AM	#28 (permalink)
Chuck33079 A True Z Fanatic Join Date: Nov 2011 Location: Houston Posts: 12,265 Drives: 2011 370ztt Rep Power: 29538	Are you running aftermarket wheels and tires? If you're on stock wheels and tires and he can't get the alignment right with camber arms and toe bolts installed, I'd try another place. __________________ 2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

02-03-2014, 08:32 AM	#30 (permalink)
Chuck33079 A True Z Fanatic Join Date: Nov 2011 Location: Houston Posts: 12,265 Drives: 2011 370ztt Rep Power: 29538	I can't see those spacers making that big of a difference in camber. I'd go try another alignment shop. __________________ 2011 MB Touring-Sport-6sp-Nav/GTM TT/FI TT TDX/JTran/Kosmic/Eibach/Hotchkis/SPC/CSF/RPS/SoThatsWhereAllMyMoneyWent

02-02-2014, 10:53 PM	#18 (permalink)
Alexwallace23 Base Member Join Date: Feb 2013 Location: Arizona Posts: 124 Drives: 2012 370Z Rep Power: 12	So I finally installed the coilovers and my friend that said that I would not need camber kits was wrong and all of you here are right. I did get Kinetics rear camber and traction kit just to be on the safe side and I am now about to buy a camber kit for the front since Stance only makes the front coilovers with built in camber plate for vehicles with McPherson type suspension. Yes I should have been able to figure this out prior to installing the coilovers but the same friend said it had the front camber plate. The shop that did the install pretty much set it to the lowest. It did look great but I scraped the mid section of the exhaust pipe really hard while going into my own garage. So I had to raise it up about an inch. Once I get the front camber kit I will do another alignment and I should be able to get everything back to spec.

02-03-2014, 01:35 AM	#19 (permalink)
RICAN Enthusiast Member Join Date: Jan 2013 Location: fort hood, tx Posts: 345 Drives: 2012 370z m6 Rep Power: 12	pics!!....i want to see how low your car is!!

02-03-2014, 05:34 AM	#21 (permalink)
RICAN Enthusiast Member Join Date: Jan 2013 Location: fort hood, tx Posts: 345 Drives: 2012 370z m6 Rep Power: 12	ok thanks!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[WTB] Coilovers	VolcanoG07	Parts for sale (Private Classifieds)	12	10-10-2011 11:28 PM
looking for coilovers.	F.LadyZ	Canada	11	08-26-2011 02:58 PM
FS BC BR coilovers-	racerxj17	Parts for sale (Private Classifieds)	19	11-18-2010 12:23 PM
great info about coilovers vs springs..i may jus save up for coilovers instead	res0zsfa	Brakes & Suspension	15	09-09-2010 07:05 PM