|
I just had an alignment after coil over install. I only have rear camber kit so he got that into .02 degrees of stock. The fronts are almost 1.2 higher
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-19-2012, 04:07 PM
|
#15 (permalink) |
|
A True Z Fanatic
Join Date: May 2010
Location: Tampa
Posts: 4,207
Drives: RZ34
Rep Power: 31941   |
I just had an alignment after coil over install. I only have rear camber kit so he got that into .02 degrees of stock. The fronts are almost 1.2 higher then stock. That is the best he could get them until I get front arms. He did bring them in some I wish I had a scanner to scan the print out. I will try and take a picture and post it.
__________________
Project Z <--Click - Check out the link too many mods to list! |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem with front SPC camber kit...help needed | docaam | Brakes & Suspension | 8 | 06-15-2016 01:05 PM |
| Camber kit with Swift Spec R lowering springs? | JAYNO20 | Brakes & Suspension | 13 | 08-29-2012 04:15 PM |
| Torque spec needed for front shock's bottom bolt | mattjk | Brakes & Suspension | 9 | 09-04-2010 06:33 AM |
| SPC Rear Camber Kit Test Car Needed | THMotorsports | Brakes & Suspension | 3 | 03-03-2009 02:36 PM |
| SPC Rear Camber Kit Test Car needed! | THMotorsports | THMotorsports | 11 | 03-03-2009 02:32 PM |
Threaded Mode
