Oddly enough it did for the rear and not for the front. Added my own to the front during my end of season caliper rebuild.

:ugh2:

Weird.

If a little more attention from the community shows up with interest I will start the project and become an advertiser here so that I may start a Intro pricing kit GB or something along those lines. Right now this is a feeler and 2-3 people show interest which I am noting. Thanks for all the replys so far guys.

http://s8.postimage.org/wkb2kbrrp/IMG_0597r.jpg

http://s12.postimage.org/b9x6amb71/a...temodel002.jpg

That's brake porn in the fullest....

A month later and I have not seen any new posts. I will assume this is a dead request at this point.

Hey, I'm still interested. :D

Interested in 2 peice front/rear rotors.

that F1 set up is beautiful!!!

Yeap! :D

1) Rusty
2) BlkNismo

2 piece front rotors

1) Rusty (Front+Rear)
2) BlkNismo (Front+Rear)
3) takjak2 (Front)

I'm interested in two piece front and rears, slotted. Can you get the Alcon rotors? They fully float but do clunk a bit at low speeds. But that's what full floaters do.

Would prefer not using Alcon. AP Has better options and makes a better Rotor ring all together. J-Hook, Curved Groove and Straight Groove are all options. The engineering is my part. What you want is up to you. Thats the purpose of this thread. If enough interest comes about then I will dedicate the time disclose some pricing and pay advertiser fees on the forum.