Gauging Interest: FULL Titanium Eccentric Bolt Eliminator Kit

Txernyuk

Hello!

In my pursuits to constantly improve my Z, I have finally found a way to put together a Titanium (Grade 5) Eccentric Bolt Eliminator kit. From what I can find on the web, this has never been done before. A stack consists of a bolt, two washers, and nut. This combination can be easily scaled between quantities of 2 stacks (for Camber or Toe) or 4 (for Camber and Toe) with minor cost savings per stack for the latter.

I included a dimensional drawing of the OEM setup, as measured on my own vehicle.

Blue = Bolt Head

Green = Existing Eccentric Washer

Black = Car attachment point

Red = Nut

Grey = Bolt Body

The bolt and nut in the Titanium kit are more dimensionally optimized, reducing OEM lengths by approximately 2mm each.

The original goal was to make the most elite kit possible for my own vehicle, but I came to wonder if anyone else was interested perhaps there are some cost savings for bulk/batch ordering. The best I can get so far is about $30/stack before tax/shipping, but that's as a single person...I wonder how low it can go.

Reply for questions
PM for interest

Attached Images

Eccentric Bolt Stackup.png (61.5 KB, 16 views)