|
Originally Posted by martin82 You can check with a multimeter to see if ur voice coils are blown..... I have one wire desolder on the vc going to the sub
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
05-27-2012, 03:17 PM
|
#16 (permalink) | |
|
A True Z Fanatic
Join Date: Dec 2011
Location: Philadelphia
Posts: 15,476
Drives: 370z / R32
Rep Power: 220    |
Quote:
I didn't check with a meter yet, but I checked the wires on the voice coil and both and taut and connected. |
|
|
|
|
05-29-2012, 12:56 AM
|
#17 (permalink) | |
|
A True Z Fanatic
Join Date: May 2010
Location: Calgary
Posts: 1,861
Drives: 90 and 15 GMC Sierra
Rep Power: 420 |
Quote:
 That was in 2011, as stated on the box, this is 2012...But seriously you'll most likey have to go after where you bought them, If JL says they are not a dealer, you bought them from them at your own risk. |
|
|
|
|
|
05-29-2012, 02:15 PM
|
#18 (permalink) |
|
The370Z.com Sponsor
 
Join Date: Jan 2010
Location: Kingston, NH.
Posts: 469
Drives: 98 Supra 1036 RWHP
Rep Power: 15 |
Well I must say it is not a DUD... It was working for 3 weeks. In this case it is not like it came out of the box defective... so something happened between now and then that caused it...
Your warranty at this point is with Sonic... give them a call... Reason JL does not warranty their products if you do not buy it from an authorized dealer is because, these dealers go through the training to make sure amps are set up properly. In this case I am not saying it was not... But simply saying this sub worked for 3 weeks, if it was a dud it would have been DOA. It is best to run 2 subs with a combined channel, Like a MONO amp or bridge the amp. This way if there is any power fluctuation between the amps leftand right channels, subwoofers are not trying to fight each other trying to produce sound. Questions on your system set up... Are you running a sealed box with 2 chambers? meaning does each sub have it's own enlcosure... I read from comments on your post you have a 2 Channel amplifier... Are you running left channel to one sub and right channel to the other sub? If you are running a 2 channel amp, you will need a box that is divided. If you have a box that is all one chamber, meaning there is NO divider between the subs, you will need to bridge the amp and run it to the subs bridged... Providing you have the correct impedence when you matched up your subwoofers with your amp. (this will not be possible to do unless you have the correct impedence) Most 2 channel amps will give you XXX RMS x 2 at 4 ohms If you bought 4 ohm subs then you are most likely stuck with what you got. Unless your amps output bridges to 2 ohm stable. then you can take parrallel the subs and run them together... What is the amp you are running?
__________________
 www.wickedcas.com Call: 603-642-4222 E-mail: Wickedcas@aol.com DIRECT AUTHORIZED DEALER FOR: AUDISON, HERTZ, JL AUDIO, JL AUDIO MARINE, KENWOOD EXCELON, COMPUSTAR, DIAMOND AUDIO, CACHE, ARC AUDIO, K40, PASSPORT ESCORT. Last edited by Wicked CAS; 05-29-2012 at 02:18 PM. |
|
|
|
|
05-29-2012, 02:38 PM
|
#19 (permalink) |
|
A True Z Fanatic
Join Date: Dec 2011
Location: Philadelphia
Posts: 15,476
Drives: 370z / R32
Rep Power: 220 |
^ I'm using a Hifonics Bxi1600 and the subs are 2ohm. Bigaudiofanat did the install, not me, so maybe he can chime in with any technical info if he reads this. The box is divided and each channel on the amp is powering a sub.
|
|
|
|
|
05-29-2012, 03:02 PM
|
#20 (permalink) | |
|
The370Z.com Sponsor
Join Date: Jan 2010
Location: Kingston, NH.
Posts: 469
Drives: 98 Supra 1036 RWHP
Rep Power: 15 |
Quote:
•RMS Power Rating: ◦4 ohms: 550 watts x 1 chan. ◦2 ohms: 1100 watts x 1 chan. ◦1 ohm: 1600 watts x 1 chan. •MOSFET Power supply •Super D-Class amplifier relies on a super-speed enhanced chip-set to produce higher current capacities and more precise digital to analog conversions •Wired remote bass level control included •Power and Protection LED indicators •Built-in system diagnostics offer protection of DC, Speaker short, terminal, and overload •Tuned Bass EQ (0-10 dB bass boost at 45 Hz) •Dampening factor: >250  You have a MONO AMPLIFIER If you have 2 ohm subs (each) that means you are running the amp at 1600 WATTS.. JL AUDIO 10w3v3 as you mentioned is rated at 300 watts each.. that is only 1000 watts more then they are rated at...  Unless your subs are wired in series and that does not seem to be the case from your original post... Notice also the dampening factor on the amp is 250 meaning control over your subwoofer is not as good as a let's say a JL Audio amplifier. A JL AUDIO XD600/1 with 600 Watts of power would have been a perfect match for your subs (needed 4 ohm subs)... Here are the specs for example... Damping Factor @ 4 Ω >1000 / 50 Hz Damping Factor @ 2 Ω >500 / 50 Hz
__________________
www.wickedcas.com Call: 603-642-4222 E-mail: Wickedcas@aol.com DIRECT AUTHORIZED DEALER FOR: AUDISON, HERTZ, JL AUDIO, JL AUDIO MARINE, KENWOOD EXCELON, COMPUSTAR, DIAMOND AUDIO, CACHE, ARC AUDIO, K40, PASSPORT ESCORT. Last edited by Wicked CAS; 05-29-2012 at 03:07 PM. |
|
|
|
|
|
05-29-2012, 03:06 PM
|
#21 (permalink) |
|
A True Z Fanatic
Join Date: Dec 2011
Location: Philadelphia
Posts: 15,476
Drives: 370z / R32
Rep Power: 220 |
^ shouldn't it be 550rms per sub?
Yeah, and my gain is actualy set quite low, as well as my volume level. I doubt the subs are gettin anywhere near that on a regular basis. Last edited by Vertigo; 05-29-2012 at 03:12 PM. |
|
|
|
|
05-29-2012, 03:16 PM
|
#22 (permalink) |
|
Car Audio Installer
Join Date: Jun 2009
Location: Magnolia DE
Posts: 8,342
Drives: 2012 Infiniti G37x
Rep Power: 852  |
Correct Jim, your gain is almost at its lowest setting your not getting near that.
__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/ |
|
|
|
|
05-29-2012, 03:18 PM
|
#23 (permalink) | |
|
The370Z.com Sponsor
Join Date: Jan 2010
Location: Kingston, NH.
Posts: 469
Drives: 98 Supra 1036 RWHP
Rep Power: 15 |
Quote:
Gain being all the way down means nothing, as all you are doing with gain is matching the output of your head unit to the amps input levels. So the way you are running it is potentialy 900 watts per sub... All it takes is one heavy bass note at that kind of power to fry a sub that is rated at 300 watts nominal power with a peak rating of 500 in the red zone. Hifonics also does not have the best specs and control over your subwoofer which does not help the matters... Now next question, what is the internal volume for each chamber of the enclosure?
__________________
www.wickedcas.com Call: 603-642-4222 E-mail: Wickedcas@aol.com DIRECT AUTHORIZED DEALER FOR: AUDISON, HERTZ, JL AUDIO, JL AUDIO MARINE, KENWOOD EXCELON, COMPUSTAR, DIAMOND AUDIO, CACHE, ARC AUDIO, K40, PASSPORT ESCORT. Last edited by Wicked CAS; 05-29-2012 at 04:30 PM. |
|
|
|
|
|
05-29-2012, 07:44 PM
|
#25 (permalink) | |
|
Car Audio Installer
Join Date: Jun 2009
Location: Magnolia DE
Posts: 8,342
Drives: 2012 Infiniti G37x
Rep Power: 852 |
Quote:
Their both single 2 ohm woofers, so were not running at 1 ohms were running at 4 ohms. So even at full tilt he would only be giving each sub 275 10W3v3-2 - Car Audio - Subwoofer Drivers - W3v3 - JL Audio Correction I think you are right wicked, I wired it at 1 ohm not 4, although I think he is still not pushing 800 watts or near it with the gain almost fully down.
__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know Direct email address reimermatt@gmail.com Owner of: Dynamic Mobile Audio Follow me below https://www.facebook.com/Dynamicmobileaudio/ Last edited by bigaudiofanat; 05-29-2012 at 08:27 PM. Reason: Correction |
|
|
|
|
|
05-29-2012, 09:12 PM
|
#26 (permalink) |
|
Base Member
Join Date: Apr 2012
Location: Mathews, AL
Posts: 68
Drives: 2012 370Z Base SP M6
Rep Power: 13 |
Speakers do not 'blow' from too much power. Speakers are damaged by too little power; driving a speaker to volume levels which require a level of wattage greater than the amplifier can provide will produce 'clipping', which can easily damage a loudspeaker.
Clipping (audio) - Wikipedia, the free encyclopedia The way to damage a speaker which is driven by an adequately powered amplifier is too go berserk with the volume - causing the loudspeaker to draw more and more power, play louder and louder until it physically fails. The volume knob acts just like a dimmer switch for a light: crank it up and the bulb (speaker) draws more power and produces more light (volume), turn it down and the bulb (speaker) draws less power and produces less light (volume). |
|
|
|
|
05-29-2012, 10:22 PM
|
#27 (permalink) |
|
A True Z Fanatic
Join Date: Dec 2011
Location: Philadelphia
Posts: 15,476
Drives: 370z / R32
Rep Power: 220 |
My volume was never played at high levels, maybe 15/40 max. Also, my working sub is just fine. Is there any way I can test this sub to see if it's useable before I go down the tedious refund route?
|
|
|
|
|
05-30-2012, 08:18 AM
|
#28 (permalink) | |
|
Base Member
Join Date: Jan 2012
Location: Charlotte, nc
Posts: 87
Drives: 07 Element SC
Rep Power: 13 |
Quote:
To the op no matter what you can and volume level are at currently it is still possible that you were getting the full power of that amplifier. You can assume all you want that because the gain was low and volume was low that you are not but unless you set you gains with an o-scope you do not know the input voltage that amplifier is seeing to it is a real possiblity.
__________________
MECP Master Certified Installation Technician Don't worry I've never done this before |
|
|
|
|
|
05-30-2012, 09:53 AM
|
#30 (permalink) |
|
The370Z.com Sponsor
Join Date: Jan 2010
Location: Kingston, NH.
Posts: 469
Drives: 98 Supra 1036 RWHP
Rep Power: 15 |
It was blown...
That is all it matters ... It was not a DUD.... It worked for 3 weeks being overpowered... Call sonic see what they will do for you... If they give you the option upgrade to W6v2 and send both w3s in for trade... You have too much power and too much risk with the existing set up. Those subs are great subs, set up properly they will not get damaged easily.... We sell close to 200 W3 subs in the store with less then 0.5 percent defective rate... given they were matched and set up properly... Like I said all it takes is one heavy bass note... Even though gains were adjusted low... not all recording levels are the same... if you had a cd or mp3 that was recorded at +3 or +6 dp above noise level, that is the same as doubling your gain...
__________________
www.wickedcas.com Call: 603-642-4222 E-mail: Wickedcas@aol.com DIRECT AUTHORIZED DEALER FOR: AUDISON, HERTZ, JL AUDIO, JL AUDIO MARINE, KENWOOD EXCELON, COMPUSTAR, DIAMOND AUDIO, CACHE, ARC AUDIO, K40, PASSPORT ESCORT. |
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [WTB] 220 shipped for your HFC | harman.khinda | Parts for sale (Private Classifieds) | 2 | 02-28-2012 02:35 PM |
| [FOR SALE] 2010 Z Key Fob - $85 Shipped | Jeffblue | Parts for sale (Private Classifieds) | 9 | 10-12-2011 09:14 PM |
| [FOR SALE] K&N Panel Filters ($75 shipped) | 370Z TPMS Sensors ($175 shipped) | SSR Plate Frame | 370Z JT | Parts for sale (Private Classifieds) | 6 | 07-17-2011 09:29 AM |
I check the speaker wire connections from my amp to the box terminal of the nonworking sub and it seems to be just fine, but still no sound from the speaker.
Linear Mode
