|
Hi Jeff. The ground wire is running to a distribution block where the amp is being grounded. For the wires going to steering wheel controller are you sure it is
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-07-2009, 03:09 PM
|
#6 (permalink) |
|
Base Member
Join Date: Apr 2009
Location: baltimore
Posts: 104
Drives: 09 Nissan 370z PG M6
Rep Power: 18  |
Hi Jeff. The ground wire is running to a distribution block where the amp is being grounded. For the wires going to steering wheel controller are you sure it is 15 and 16. I was looking at the service manual and it shows that 15 is the "STRG SW GND" and 16 "STRG SW B". This is for the base model 370z. On you other write up you stated that the wires were blue and pink. Was this for the bose radio? Also the service manual states that in pin 6 "STRG SW A" and that is a pink wire. Your help would be much much appreciated.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY Idea: Installing Synchro Rev match | modme | DIY Section (Do-It-Yourself) | 8 | 05-28-2021 05:19 PM |
| DIY: Installing Aftermarket Radio | TennesseeZ | DIY Section (Do-It-Yourself) | 46 | 06-30-2019 09:36 PM |
| Installing Factory Navigation | rbratton | Audio & Video | 18 | 08-10-2012 06:26 PM |
| Slight problem after installing G3 intake! | Darkaeon | Intake/Exhaust | 17 | 04-24-2009 01:37 PM |
| installing a used bose on base model? | pcollatZman | Audio & Video | 1 | 03-31-2009 10:38 AM |
Threaded Mode
