Where to tap into for B.U. Cam, power, etc?

turbodog · 01-12-2011, 09:12 PM

I just downloaded the Kenwood installation manual :
http://kenwoodusa.com/UserFiles/File...60_Install.pdf

It does not mention a VSS connection. Probably why you don't see a wire to connect to. It uses the parking brake switch wire to determine if the car is in motion for safety regulation compliance.

Dubro · 01-12-2011, 09:47 PM

Thanks again Turbodog. If thats the case then I don't need a switch at all. All I need to do is permanently ground the Parking Brake wire. Now I need to find out for sure if that is truly the case.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
WTB: HKS Hi Power Ti	Footloose301	Wanted	1	10-31-2010 05:35 PM
WTB: HKS Hi-Power	hfrog355	Parts for sale (Private Classifieds)	1	10-14-2010 01:57 PM
up the power	Bigfish	Australia/New Zealand	17	06-17-2010 07:22 PM
NA Power	carfr3ak	Engine & Drivetrain	2	09-26-2009 02:19 AM
rep power?	black09Z	The370Z.com Feedback, Suggestions & Questions	3	08-12-2009 02:06 AM

01-12-2011, 09:12 PM	#1 (permalink)
turbodog Base Member Join Date: Sep 2010 Location: Dallas, TX Posts: 129 Drives: 370Z Rep Power: 17	I just downloaded the Kenwood installation manual : http://kenwoodusa.com/UserFiles/File...60_Install.pdf It does not mention a VSS connection. Probably why you don't see a wire to connect to. It uses the parking brake switch wire to determine if the car is in motion for safety regulation compliance.

01-12-2011, 09:47 PM	#2 (permalink)
Dubro Base Member Join Date: Oct 2009 Location: Alpharetta, GA Posts: 62 Drives: 2010 Nismo Rep Power: 17	Thanks again Turbodog. If thats the case then I don't need a switch at all. All I need to do is permanently ground the Parking Brake wire. Now I need to find out for sure if that is truly the case.