Where to tap into for B.U. Cam, power, etc?

csmith5888 · 04-19-2013, 07:26 PM

Quote:

Originally Posted by wheee!

I am not 100% sure about the Nismo, but the wiring harness in the dash should be the same for each model regardless of which A/V head you have. It would make sense from a manufacturing point of view. It is easy enough to disassemble and check.... all the wires you need are in the back of the A/V Head under your cubby hole.

I have been reading around quite a bit about rear camera install and have heard some different options available for tapping into the reverse signal....

I know there are reverse signal wires in both the trunk area as well as the driver side kick panel.

But then ive seen people mention that some of the 370z models have one right in the cubby hole behind the head unit. The few times ive read about it i have seen people mention it is only in z's with auto transmission. I have a 2013 sport package non bose 6spd MT. Can anyone with a manual tranny comment on this?

If there is a signal behind the HU im good to go...otherwise i gotta run a longer line elsewhere because the Pioneer harness comes with a purple reverse wire that is about 4 inches long.

Any help would be greatly appreciated. Also, on a side note. Ive read a million different comments on the E-brake video bypass. Anyone have a method with a pioneer double din that i wont need a switch for?

Most important question is the reverse signal but again, any and all help is greatly appreciated. Thanks.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
WTB: HKS Hi Power Ti	Footloose301	Wanted	1	10-31-2010 05:35 PM
WTB: HKS Hi-Power	hfrog355	Parts for sale (Private Classifieds)	1	10-14-2010 01:57 PM
up the power	Bigfish	Australia/New Zealand	17	06-17-2010 07:22 PM
NA Power	carfr3ak	Engine & Drivetrain	2	09-26-2009 02:19 AM
rep power?	black09Z	The370Z.com Feedback, Suggestions & Questions	3	08-12-2009 02:06 AM