Jayhovah's fiberglass sub box build log

BoneZ · 01-07-2018, 09:07 PM

Quote:

Originally Posted by Jayhovah

Thanks! Did you mix 50/50? What consistency did you go for? Runny at all? Or just tilt the box and watch it slowly slide around?

I've also thinned body filler down with acetone in the past and it works GREAT. I could probably get it much thinner than I could with resin but I may go with the resin just for the added stiffness.

I just added Bondo to the resin until it created a thick yet decent flowing consistency. Definitely thin enough to flow around the Box when tilted.

redondoaveb · 01-07-2018, 09:16 PM

Question from the audio challenged. I know you're fabricating a sealed enclosure but is it critical to seal the pin holes?

Jayhovah · 01-07-2018, 09:30 PM

Quote:

Originally Posted by redondoaveb

Question from the audio challenged. I know you're fabricating a sealed enclosure but is it critical to seal the pin holes?

For sure!! I have seen cones tear from the resistance of having to push/pull air through the pin holes. Even if it isn't that catastrophic, it's going to distort the sound.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Jayhovah's Gamma V3 TT Install Pic/Video Dump	Jayhovah	Forced Induction	25	05-14-2017 08:37 AM
Jayhovah's Build Journal	Jayhovah	Member's 370Z Gallery	13	10-30-2014 01:42 PM
Custom Fiberglass Sub Box	CSA0890	Audio & Video	0	11-26-2012 10:06 PM
fiberglass box	im89	Audio & Video	7	02-04-2011 03:57 PM

01-07-2018, 09:16 PM	#2 (permalink)
redondoaveb A True Z Fanatic Join Date: Apr 2017 Location: So. Commiefornia Posts: 6,386 Drives: 2014 Nismo Gunmetal Rep Power: 2684376	Question from the audio challenged. I know you're fabricating a sealed enclosure but is it critical to seal the pin holes?