Running new speaker wiring. Help!

teejnut · 11-15-2009, 11:23 PM

here are some pics... and tips for others in the future

first you have to push the little tab on the side in as seen here next to my thumb.

after you do that you can pull down the lever like this. you'll need to close the door partially to pull down the lever. once the lever gets pulled down it'll pop out.

after this is out you can pull out the female side from the inside of the car by sticking your hand in where the kick panel cover use to be. to remove this pull from the bottom. and then on a non-bose system you can drill a hole through one of the sections thats not used to run the speaker wire. to install just put the female section back in... top first and the bottom will snap in.

then for the gray lever piece, pull the lever all the way down and push it in and then push the lever up to lock it back in place.

and another tip is use a coat hanger or something similar to run the speaker wire through the rubber hose, makes it easy!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Daytime Running Lights	TacoZ	Exterior & Interior	76	03-07-2015 09:01 PM
Speaker Wiring	bpd138	Audio & Video	24	09-04-2009 02:36 PM
After running in,better power.?	Chan Chee Hoe	Nissan 370Z General Discussions	1	06-16-2009 08:32 AM
What tires are you running?	rreign	Wheels & Tires	39	06-02-2009 08:06 PM
Speaker Wiring Help Request	DarinFred	Audio & Video	3	03-14-2009 10:15 PM

11-15-2009, 11:23 PM	#11 (permalink)
teejnut Base Member Join Date: Sep 2009 Location: Burbank, CA Posts: 206 Drives: 09 Z34 Sport/6MT Rep Power: 17	here are some pics... and tips for others in the future first you have to push the little tab on the side in as seen here next to my thumb. after you do that you can pull down the lever like this. you'll need to close the door partially to pull down the lever. once the lever gets pulled down it'll pop out. after this is out you can pull out the female side from the inside of the car by sticking your hand in where the kick panel cover use to be. to remove this pull from the bottom. and then on a non-bose system you can drill a hole through one of the sections thats not used to run the speaker wire. to install just put the female section back in... top first and the bottom will snap in. then for the gray lever piece, pull the lever all the way down and push it in and then push the lever up to lock it back in place. and another tip is use a coat hanger or something similar to run the speaker wire through the rubber hose, makes it easy!