11-04-2015, 08:41 PM
|
#4 (permalink)
|
|
Base Member
Join Date: Jun 2015
Location: Virginia
Posts: 71
Drives: 2014 370Z midnight
Rep Power: 10
|
Quote:
Originally Posted by bigaudiofanat
No problem man, I have done the pin swap myself it's easier to buy a second harness and tear it down.
|
I was planning on doing this and have a question for you. I installed an AVIC-8000 in my 2014 bose model (no nav). The Metra harness had a black wire on the opposite side of the plug from the power wire, which said, "for subaru only". I was told that the AVIC-8000 ground wire needed to be directly grounded to chassis (not using the black wire from the Metra plug which appeared to plug into the factory black wire). I DID do that, but was wondering: Should I ground the "for subaru only wire" and connect that to the ASWC-1? It looks like I will need to grab ignition 12V and install the pins for the other two control wires. I think there is a 3.5mm jack on the back of the AVIC for the AWSC-1 to plug into. Any other gotcha's?
|
|
|
Similar Threads
2Likes
Threaded Mode
