02-17-2016, 06:29 AM
|
#2 (permalink)
|
|
Enthusiast Member
Join Date: May 2015
Location: Annapolis, MD
Posts: 277
Drives: 2011 Nissan 370Z
Rep Power: 12
|
Quote:
Originally Posted by CanadianSteel
No more updates on this?
|
Yes there are, as a few people mentioned I found too many areas of concern on this print. Including the biggest problem was the scale factor was too large. As well as a few really low spots on the part (too low for body filler). If I was to try and flex it into place the bondo would crack. 
So I had to take a very frusterated step back and find out what happened. After taking some time to figure out where the scale factor went wrong and adjusting some more blemish areas I will be ready to print again. I have taken into consideration the concern of a few of you about the top of the dash being too high. So I am trying to hold the shape of the original dash with this design and inset the monitor a little bit more. I will keep you all updated with images as work progresses.
__________________
ANTHONYSORG
|
|
|
Similar Threads
550Likes
Hybrid Mode
