08-05-2015, 06:53 PM
|
#11 (permalink)
|
|
Enthusiast Member
Join Date: May 2015
Location: Annapolis, MD
Posts: 277
Drives: 2011 Nissan 370Z
Rep Power: 11
|
Quote:
Originally Posted by Sycobob
Just a thought: if the tabs are causing problems for production, they could potentially be separate pieces that screw into the main piece. It introduces an extra point of failure, but it allows the tabs themselves to be manufactured separately and be replaceable. So depending on your goals it may or may not be preferable.
|
If I decide to stay with the molds over injection molding that is what I have been looking into. I had intended on using an epoxy mounting system. When it comes to production those tabs will most likely be too small and too oddly shaped to work well with the molds anyway. The screws may definitely be a stronger solution than the epoxy where room allows. 
__________________
ANTHONYSORG
|
|
|
Similar Threads
550Likes
Threaded Mode
