The "Will it fit?" thread

[Shane_Z]

Originally Posted by Spooler

You can fit whatever you want. I have SSR MS3's. On front I have 19x10 +29 and rear are 19x11.5 +30. I run R888r's 285/35/19 front and 325/30/19 rears. You must have a fully adjustable suspension to make it happen. Camber up front is -1.5 and rear is -1.4.

Thanks for the reply. Currently, I'm on stock suspension but would be upgrading to a good adjustable setup in the future.

[Spooler]

Originally Posted by Shane_Z

Thanks for the reply. Currently, I'm on stock suspension but would be upgrading to a good adjustable setup in the future.

Save up and do the suspension first. Then do wheels and tires. That is what I did. I am on Aragosta coilovers. Take your time or you will do it twice.

[OptionZero]

Originally Posted by Shane_Z

Thanks for the reply. Currently, I'm on stock suspension but would be upgrading to a good adjustable setup in the future.

Brake clearance is not dependent on the size of the wheel, it depends on the spoke design which is specific to each wheel.

No one can tell you if those wheels will clear brakes because no one has them
I'm assuming these are fake multipiece given the price?

You will need to contact the wheel "manufacturer" to see if they can provide exact measurements or have any experience with clearing 370Z sport brakes (they are made by Akebono, so we call all the Sport/Nismo brakes Akebonos)

You need to read THIS thread to answer all of your fitment questions:
Wheel Fitment 101: START HERE

[Shane_Z]

Originally Posted by OptionZero

Brake clearance is not dependent on the size of the wheel, it depends on the spoke design which is specific to each wheel.

No one can tell you if those wheels will clear brakes because no one has them
I'm assuming these are fake multipiece given the price?

You will need to contact the wheel "manufacturer" to see if they can provide exact measurements or have any experience with clearing 370Z sport brakes (they are made by Akebono, so we call all the Sport/Nismo brakes Akebonos)

You need to read THIS thread to answer all of your fitment questions:
Wheel Fitment 101: START HERE

Hey thanks for the link to your thread! Very helpful. I received a technical drawing of the wheel I want from the manufacturer, seems like I will need to run a spacer to clear the brakes.

After reading some threads and asking around, I'm still unsure about how wide you can go with wheels (with an adjustable suspension setup). The setup I'm looking at (19x9.5+25 with 10mm spacer) compared to the stock rays (19x9+47) would poke out 38.5mm. How much camber would you approximately need to make this sit flush if needed at all?