|
I recently had the VEL Control module replaced as a result of error codes P1092, P1091. I did the VVEL Control Shaft Position Sensor voltage adjustment per manual using Cipher.
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-07-2018, 10:08 AM
|
#1 (permalink) |
|
Base Member
Join Date: Apr 2011
Location: Florida
Posts: 159
Drives: 2010 370Z Sport
Rep Power: 15  |
Error code U1024
I recently had the VEL Control module replaced as a result of error codes P1092, P1091. I did the VVEL Control Shaft Position Sensor voltage adjustment per manual using Cipher. P Codes are gone and I can drive the car, but now I’m getting error code U1024 and don’t know what is causing it. Can anyone help?
Here is a list of my add-on/mods: 1. UpRev 2. Berk High Flow Cats and Cat aBack Exhaust 3. Nismo Cold Air Intakes 4. Mishimoto Aluminum Radiator 5. Oil & Power Steering Coolers Any help would be much appreciated. Thanks!
__________________
10 370Z Sport|Berk CBE & HFC|NISMO R-TUNE CAI|Z1 Oil & PS Coolers|Mishimoto Radiator|UpRev|Nismo S-Tune|SEIBON Spoiler|Eibach Sways, Springs, Spacers|SPC Camber|RJM Clutch Pedal|Enkei Wheels|StopTech Rotors & Pads|SS Brake/Clutch Lines|Alpine W900BT, PDX5, Rear Camera, Boston SR60, S35 & 10" G3 Sub|3M Ceramic Tint |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone seen this code? U1024,VVEL CAN communication | COSMO | Forced Induction | 30 | 07-26-2019 10:22 PM |
| Trouble code U1024 | john26jm | Tuning | 2 | 02-22-2015 08:30 PM |
| i got two error code on the scanner help! | tommy_nick | Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs | 2 | 09-20-2014 09:01 PM |
| Error Code P0605 Internal Control Module Read Only Memory (ROM) Error | Fearless_Z | Tuning | 3 | 02-10-2013 07:35 AM |
| Code U1024 | Megan370z | Tuning | 9 | 03-15-2010 08:15 PM |
Threaded Mode
