Error code U1024

cdoxp800 · 05-07-2018, 09:14 PM

Quote:

Originally Posted by Stino

I recently had the VEL Control module replaced as a result of error codes P1092, P1091. I did the VVEL Control Shaft Position Sensor voltage adjustment per manual using Cipher. P Codes are gone and I can drive the car, but now I’m getting error code U1024 and don’t know what is causing it. Can anyone help?

Here is a list of my add-on/mods:

1. UpRev
2. Berk High Flow Cats and Cat aBack Exhaust
3. Nismo Cold Air Intakes
4. Mishimoto Aluminum Radiator
5. Oil & Power Steering Coolers

Any help would be much appreciated. Thanks!

You will have to drive the car to clear the Code. You have to be over 55 so many min. I was try to fin the info in the service Manuel. I replace my VVEL module last month. then drove the car a total of 15 miles at speed of greater then 45mph. Check the coded when I got home. All Clear

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Anyone seen this code? U1024,VVEL CAN communication	COSMO	Forced Induction	30	07-26-2019 10:22 PM
Trouble code U1024	john26jm	Tuning	2	02-22-2015 08:30 PM
i got two error code on the scanner help!	tommy_nick	Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs	2	09-20-2014 09:01 PM
Error Code P0605 Internal Control Module Read Only Memory (ROM) Error	Fearless_Z	Tuning	3	02-10-2013 07:35 AM
Code U1024	Megan370z	Tuning	9	03-15-2010 08:15 PM