DRAG WHEEL/Tire setups

Originally Posted by andre12031948

Wait till early next spring(new radials may come out) go to a site like JEGS. Check out street/drag radials from M/T, Nitto, & Hoosier & anyone else that may offer something by spring.
Also find 2 wheels, only two in the 17"-18" size by apx. 10" wide. You can race with spacers in the front. As far as the rear, Jegs can help you get the right offset/size to fit your car, w spacers or without. Weld wheels was my choice for the slicks, but they Jegs can help you.

Get a good rear set up that can be put on your car hours/days before you go to the track. On that day JUST drive to the track with those tires/wheels on, & the stock setup in the front. If you can get a front brake lock-up system or I think you can just remove the rear brake fuse??/ then all you'll do is drive to the track, have a cup of coffee, pull into the water box first, lock front brakes & smoke the rear tires till a bunch white smoke appears in your side & back mirrors. The starter will also wave you to go forward to the starting line. Part of their job is to tell you when your ready. Lift the clutch & floor the gas at apx. 4,500 to 5,000 something rpm. Experiment. You should be able to do 1.5 to 1.7's 60' times & very good 1/4 ET's.

Not much to do at the track & do great times & have fun. Good luck. Also it sounds like you have a very nice setup....

I did that when I stated with my 08 z. If you go to dragtimes.com, browse, hit Nissan 350z. I'm on the first page(bottom) Someone made a video of my run with the exact set up I just mentioned. I didn't even hear of forums then. Soon I was told that the run 12.9 put me in the # one spot of 350z.com. I didn't know or care at that time. Had stock wheels/tires in the front....