Tampa Fl Roll Call

Nut_N_Much

Thinking of this! Doesn't matter how many vents I put or were because the underside is getting a boxed in completely. I want to make 2 openings that the vents would draw the heat out from. Also helps with water and debris falling in engine bay as it would connect with the stock from part of the under hood and allow it to drain as needed. Also cleans up the underside of the hood.

I measured the hood and laid a line down the center to use as my half way mark. I plan on keeping the Vents in front of that 1/2 way mark. A few others on the forum did this with 2 vents and had good reviews. That area gets the most pressure to draw heat out. 70 mile hr with windows down and feeling the heat from the engine bay pass over the windshield is a good thing.

Instead of strait cuts I'll use a slight curve and make each vent slightly wider giving it a nice look.

Thread that inspired me: Vented hood thread

Photo Gallery 1st day: Lines have been revised since these photo's: Nissan 370Z Forum - Nut_N_Much's Album: Hood

Attached Images

screenshot_1_30_13_1_42_pm.jpg (100.2 KB, 18 views)

__________________

Did new cool science stuff to the car !!!
http://www.the370z.com/mazoc/99606-z...y-14-17-a.html
http://www.the370z.com/diy-section-d...-w-videos.html