Nissan 370Z Forum  

370Z Forums HOME My Picture Album Nissan 370Z Pictures Premium Membership Become a Forum Sponsor
Go Back   Nissan 370Z Forum > Search Forums
Reload this Page Search Results
Register All Albums FAQDonate Members List Calendar Today's Posts


Page 1 of 6 1 23 Last »
Showing results 1 to 25 of 134
Search took 0.01 seconds. Search: Posts Made By: Girald
Forum: Engine & Drivetrain 12-30-2023, 07:06 PM
Replies: 25
Views: 3,414
Posted By Girald
LOL im in the same mess.. Started my car...

LOL im in the same mess..

Started my car and drove it home 30 min... was hearing some occasional tick or noise somewhere there-abouts in the vicinity of the starter.. I had the left turbo ( its a...
Forum: Track / Autocross / Drifting / Dragstrip 07-06-2023, 11:59 AM
Replies: 55
Views: 9,647
Posted By Girald
To find the module, just Google 370 vdc location ...

To find the module, just Google 370 vdc location

If you have switch blanks instead of switches by the cup holder, you can pop 1 out and use a switch you bought from Amazon

Just cut 1 lead...
Forum: Engine & Drivetrain 03-10-2023, 10:38 PM
Replies: 16
Views: 7,967
Posted By Girald
Super late response, but I ran into this thread...

Super late response, but I ran into this thread from a casual google search, figured id chime in..

P0820 refers to the cream little square box with a connector that looks like it comes out but...
Forum: Engine & Drivetrain 11-28-2022, 01:39 AM
Replies: 3
Views: 778
Posted By Girald
How do I install non revmatch reverse switch?

So i have a Sport tech 370z. I have had the engine out more than a few times. On 1 of those occasions, i accidentally got the gear position sensor wire snagged on the trans tunnel shielding mounting...
Forum: Track / Autocross / Drifting / Dragstrip 11-28-2022, 12:01 AM
Replies: 299
Views: 45,938
Posted By Girald
ABS is the parent software governing ice mode.. ...

ABS is the parent software governing ice mode..

its a traction and wheel slip issue... it has nothing to do with the mechanical brake system itself. The car software is basically tracking wheel...
Forum: Nissan 370Z General Discussions 11-27-2022, 11:21 PM
Replies: 108
Views: 33,716
Posted By Girald
lol... It is factory limited at 155. if you...

lol...

It is factory limited at 155. if you see more or less on the speedo, it is a small variance in speedo calibration.. if you see a variance on gps, it is a question of calibration vs. wheel...
Forum: Track / Autocross / Drifting / Dragstrip 09-07-2022, 06:35 AM
Replies: 299
Views: 45,938
Posted By Girald
The best solution i can think of lies in brake...

The best solution i can think of lies in brake management and added rear downforce to fight rear lockups... downforce is definitely your friend...

There are some brake "tuning" solutions to limit...
Forum: Forced Induction 08-22-2022, 08:46 AM
Replies: 2
Views: 803
Posted By Girald
Tires for Forced Induction

Anyone sticking with Pilot Sport 4s?
Im about to buy these or sport cup 2s.

I know that MTs, NT05s, 1s. and 888Rs are the goto, but I need a compound that can stick on the street but with...
Forum: Exterior & Interior 08-22-2022, 07:50 AM
Replies: 32
Views: 10,869
Posted By Girald
So, a bit more of an update on my Braniac...

So, a bit more of an update on my Braniac setup... This truly is a project for people who like tinkering. Some FYI on things that i solved or am in the process of solving on this kit

For the...
Forum: Audio & Video 08-22-2022, 06:22 AM
Replies: 5
Views: 1,758
Posted By Girald
Hello.. I have a 2015 sport tech with bose...

Hello..
I have a 2015 sport tech with bose etc... i installed this kit and it works great.

It does take some tooling behind the dash to get it running right. It sounds as if the previous owner...
Forum: Engine & Drivetrain 11-23-2021, 09:36 PM
Replies: 1
Views: 1,114
Posted By Girald
Re-Learn procedure for 6mt gear position module?

15 sport tech ( rev match ) 6mt ....


So, i a had a wonderful experience ripping out the gear position module wire when i put the engine/tranny back in to the car. Damn trans heat shield mount...
Forum: Forced Induction 11-23-2021, 09:22 PM
Replies: 29
Views: 12,692
Posted By Girald
Update from my last post... The PCV and CCV...

Update from my last post...

The PCV and CCV definitely breathe together.. Originally i posted that adding the PCV to the catch can would be the answer, with vented CCV...

not the case... so the...
Forum: Engine & Drivetrain 08-22-2020, 08:59 AM
Replies: 1
Views: 911
Posted By Girald
wooha if ebay didnt come through ..... zzzz...

wooha if ebay didnt come through ..... zzzz hunting for this was like hunting for treasure at the bottom of the ocean....

Just in case someone runs into this problem..



from the back of the...
Forum: Engine & Drivetrain 08-22-2020, 07:56 AM
Replies: 1
Views: 911
Posted By Girald
Need help - TCM gear selection box wires

Putting the tranny back in and the wires got pulled from the gear selection box at the top of my 6mt transmission

I can take out the box and re-terminal the wires, but i need to know what the...
Forum: Nissan 370Z General Discussions 08-21-2020, 02:39 PM
Replies: 18
Views: 10,704
Posted By Girald
In my case, the gear position sensor wire got...

In my case, the gear position sensor wire got snagged putting the motor/trans back in the car from the nose. The s-mode warning came up right away, the gear number under the tach was blank.


Im...
Forum: Forced Induction 08-19-2020, 06:48 PM
Replies: 7
Views: 1,605
Posted By Girald
Shes running now... just a cylinder6 misfire...

Shes running now... just a cylinder6 misfire atm... going to pull and swap plugs and see what happens... If its injectors ill have to go to a shop that tests and cleans out injectors.

Ill drop a...
Forum: Forced Induction 08-16-2020, 11:16 PM
Replies: 7
Views: 1,605
Posted By Girald
Just an update: ive got most of the car...

Just an update:

ive got most of the car done, just need to put the radiator housing back and finish up.. i took a break ( sometimes you need to step back)

But, im back at it tonight... Some...
Forum: Forced Induction 08-16-2020, 11:04 PM
Replies: 7
Views: 1,605
Posted By Girald
I set the fuel pressure per tuner's request......

I set the fuel pressure per tuner's request... Fuel pressure is a moving target since the fuel pressure regulator adjusts pressure via the vacuum pressure. Maintaining a strong fuel system to...
Forum: Forced Induction 08-10-2020, 11:56 AM
Replies: 11
Views: 1,723
Posted By Girald
Ill have to go look for that hole.. thx... for...

Ill have to go look for that hole.. thx... for most of my relays and upgrades, ive just been stuffing the ecm hole... reminds me of prom night :rofl2:
Forum: Forced Induction 08-10-2020, 12:55 AM
Replies: 11
Views: 1,723
Posted By Girald
http://www.the370z.com/forced-induction/134525-blo...

http://www.the370z.com/forced-induction/134525-blowing-my-tted-motor-swapping-new-one-back.html#post3953427

Cant say what did it except that ive run this car full blast since ive bought it... at...
Forum: Forced Induction 08-10-2020, 12:35 AM
Replies: 11
Views: 1,723
Posted By Girald
I spoke to a few guys at the track... ...

I spoke to a few guys at the track...

Apparently theres a deal where you run a 4an line into some sort of a small drum the size of a pressure regulator... the other side of that drum is filled...
Forum: Engine & Drivetrain 08-10-2020, 12:23 AM
Replies: 6
Views: 3,086
Posted By Girald
oem, you should find that the PCV is at 3/8 ID...

oem, you should find that the PCV is at 3/8 ID and the valve cover breather is 5/8ID If you buy the CJ Motorsports valve delete, you will be running -8an 1/2ID to a catch can ( in most cases)
Forum: Forced Induction 08-09-2020, 10:32 PM
Replies: 7
Views: 1,605
Posted By Girald
Blowing my TT'ed motor and swapping a new one back in

So, I blew my twin turbo'ed motor at a track event.... 7500rpms and a cylinder disintegrated. the rod essentially slapped 2 massive windows on each side until the engine wound down. The shrapnel i...
Forum: Forced Induction 08-08-2020, 11:58 AM
Replies: 37
Views: 4,506
Posted By Girald
I dont think that it was anything fuel related...

I dont think that it was anything fuel related that made the car go boom... The car was properly tuned for flexfuel and I was running e85 on that day. Fuel pressure has also been consistent through...
Forum: Engine & Drivetrain 08-08-2020, 11:48 AM
Replies: 4
Views: 3,581
Posted By Girald
DLN-7 of the FSM shows a torque spec of 55...

DLN-7 of the FSM shows a torque spec of

55 foot pounds

( attaching the driveshaft (rear propeller shaft) to the differential)
Showing results 1 to 25 of 134
Page 1 of 6 1 23 Last »

 
Forum Jump

All times are GMT -5. The time now is 10:24 PM.

Contact Us - Home Page - Archive - Top

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2