What did you do with your Z today VI (ON TOPIC DISCUSSION ONLY)

kenchan · 06-17-2015, 10:46 AM

still funny

haha

dogdamn foolz!!

Spooler · 06-17-2015, 11:24 AM

Quote:

Originally Posted by JARblue

I noticed that one dealer here in town gives me better pricing on parts than the other two. But it's not because I'm a nice customer. I have yelled at them plenty; more than once they have tried to sell me copper crush washers for my transmission and differential fill/drain plugs even when I give them the damn part number

Well, you know those washers are reusable right. I have never needed to replace a single one of them, ever.

An automatic uses the same copper crush washer on the drain plug on the older cars, probably the same for this one.

JARblue · 06-17-2015, 11:44 AM

Quote:

Originally Posted by Spooler

Well, you know those washers are reusable right. I have never needed to replace a single one of them, ever.

An automatic uses the same copper crush washer on the drain plug on the older cars, probably the same for this one.

They are noted as one-use washers in the service manual

And IMO they are not expensive enough to bother reusing (even at the full retail price of ~$2.50/washer). I did once in a pinch when the dealer screwed up and only had one washer for me (again... idiots smdh). But if you look closely, they are definitely layered and do crush slightly. You could also probably reuse the copper crush washer on the oil drain plug if you really wanted to. I choose not to. YMMV

Are you confusing the copper crush washer on the oil drain plug for the aluminum washer/gasket for transmission/differential fill/drain plugs? Not sure what you're getting at with your second statement

axmea? · 06-17-2015, 11:50 AM

Quote:

Originally Posted by JARblue

It is small, but I think it is fine as long as the car is level. But if you only jack up the front of the car, not all of the oil will drain through the opening. Then that oil flows on top of the undershroud toward the back of the car making a huge mess

Happened to me. I will make a plastic sleeve to cover any oil that flows into the top of the shroud. And not really fond of jacking up the rear to level the car. I find it to be a hassle for some reason.

Zerocool · 06-17-2015, 04:17 PM

holy crap, they charge you for the copper washer? They give them to me for free every time I go ask.

JARblue · 06-17-2015, 05:22 PM

Quote:

Originally Posted by Zerocool

holy crap, they charge you for the copper washer? They give them to me for free every time I go ask.

Yep. $0.50 apiece or something. I buy them in bulk so I don't have to deal with the parts counter idiots as frequently.

kenchan · 06-17-2015, 06:13 PM

Quote:

Originally Posted by Zerocool

holy crap, they charge you for the copper washer? They give them to me for free every time I go ask.

keep bragging about ur pretty face mang.. wtf..

no one gives me shitt. usps give me shittt...

Magic Bus · 06-17-2015, 06:56 PM

4 new MPSS installed and alignment done this morning. Of course I had to take the Z for a 30 minute drive right after, just to make sure the tires are round

I understand why onzedge always gives the

for these tires, it's a really good choice.

Zerocool · 06-17-2015, 07:56 PM

Quote:

Originally Posted by kenchan

keep bragging about ur pretty face mang.. wtf..

no one gives me shitt. usps give me shittt...

super jelly aren't ya?

axmea? · 06-18-2015, 01:33 AM

Quote:

Originally Posted by Zerocool

holy crap, they charge you for the copper washer? They give them to me for free every time I go ask.

Quote:

Originally Posted by kenchan

keep bragging about ur pretty face mang.. wtf..

no one gives me shitt. usps give me shittt...

Quote:

Originally Posted by Zerocool

super jelly aren't ya?

The more they charge you the uglier you are I guess. I use my credit card a lot

mishuko · 06-18-2015, 09:04 AM

Getting oil, clutch and brake fluids changed. Mechanics mentioned rotors could be warping so will need to look at getting new ones in the near future.

Need to do some research now

kenchan · 06-18-2015, 09:10 AM

Quote:

Originally Posted by Zerocool

super jelly aren't ya?

yep!

kenchan · 06-18-2015, 09:12 AM

Quote:

Originally Posted by Magic Bus

4 new MPSS installed and alignment done this morning. Of course I had to take the Z for a 30 minute drive right after, just to make sure the tires are round

I understand why onzedge always gives the

for these tires, it's a really good choice.

30mins will loop around entire hawaii?

Ghostvette · 06-18-2015, 09:13 AM

Quote:

Originally Posted by mishuko

Getting oil, clutch and brake fluids changed. Mechanics mentioned rotors could be warping so will need to look at getting new ones in the near future.

Need to do some research now

Unless you have over 50k miles or have been doing lots of 60-0 stops, I'd say you need to find a new mech.

Ghostvette · 06-18-2015, 09:15 AM

Quote:

Originally Posted by Magic Bus

4 new MPSS installed and alignment done this morning. Of course I had to take the Z for a 30 minute drive right after, just to make sure the tires are round

I understand why onzedge always gives the

for these tires, it's a really good choice.

Quote:

Originally Posted by kenchan

30mins will loop around entire hawaii?

At 2 am, you can almost pull it off... I'd say more like a trip to Waimanalo and back.

06-17-2015, 10:46 AM	#4486 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141520	still funny haha dogdamn foolz!! JARblue and blackcherry20 like this.

06-17-2015, 04:17 PM	#4490 (permalink)
Zerocool Track Member Join Date: Mar 2014 Location: N.Y Posts: 548 Drives: '09 370z Rep Power: 15	holy crap, they charge you for the copper washer? They give them to me for free every time I go ask. kenchan, axmea?, Luciano13 and 1 others like this. __________________ I like pizza

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[MAZOC] Official "Off-Topic" Discussion Thread	m4a1mustang	MAZOC	6670	09-06-2018 07:21 PM
The New "What did you do with your Z today" (with off topic replies) XIII	JARblue	The Lounge (Off Topic)	10011	08-04-2014 04:16 PM
What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)	AK370Z	Nissan 370Z General Discussions	10148	06-19-2014 08:20 PM
The New "What did you do with your Z today" (with off topic replies) X	eastwest2300	The Lounge (Off Topic)	10036	02-18-2014 06:26 PM
The New "What did you do with your Z today" (with off topic replies) VIII	JARblue	The Lounge (Off Topic)	10016	11-10-2013 11:21 AM

06-17-2015, 06:56 PM	#4493 (permalink)
Magic Bus A True Z Fanatic Join Date: May 2012 Location: Honolulu Posts: 1,427 Drives: 17 6MT M2 Rep Power: 18753	4 new MPSS installed and alignment done this morning. Of course I had to take the Z for a 30 minute drive right after, just to make sure the tires are round I understand why onzedge always gives the for these tires, it's a really good choice.

06-18-2015, 09:04 AM	#4496 (permalink)
mishuko A True Z Fanatic Join Date: Jul 2014 Location: bouncin on tigga Posts: 8,062 Drives: '12 Z Rep Power: 9434	Getting oil, clutch and brake fluids changed. Mechanics mentioned rotors could be warping so will need to look at getting new ones in the near future. Need to do some research now