|
Originally Posted by 6MT I think you just had bad luck. I don't think the excessive oil consumption issue is related to the break-in proceedure one way or another... and
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-22-2010, 01:24 PM
|
#4 (permalink) | |
|
Track Member
Join Date: Jul 2009
Location: Colorado
Posts: 746
Drives: '10 BC ZR T/S/Nav
Rep Power: 18  |
Quote:
 I don't think the excessive oil consumption issue is related to the break-in proceedure one way or another... and the debate will continue. What I do beleive is that with current technology and micro-finish surface verification, that break-in procedures are much less critical than they were say 20 years ago. Not to mention that almost all the tolerances are verified with CMM equipment.
__________________
'10 ZR Black Cherry Sport/Touring/Nav, Swift Springs, Stillen G3s, 15mm-F 20mm-R Spacers, SPC, Spoiler Solutions Rear Wing, Stubby Antenna 
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| New Kid on the Block | Boudreaux | New Forum Member | 12 | 05-06-2010 10:43 AM |
| New Kid on the block | BANZAIKEV | New Forum Member | 1 | 02-17-2010 10:32 PM |
| Ken Block + snow + ford = ? | shabarivas | Other Vehicles | 2 | 01-30-2010 10:30 PM |
| Block vs Dyrdek | CrownR426 | The Lounge (Off Topic) | 13 | 09-12-2009 12:41 PM |
| New kid on the block | VS-XX | Introduction | 3 | 03-21-2009 01:49 AM |
Threaded Mode
