Floor Jack

axmea?

The HF low profile jack work from the front only with a low profile ramp. I jack the front about 4 - 5 notches high on my jack stands. To lift the rear, had to get to the pumpkin by driving the jack not from the rear but from the bottom center and started pumping from underneath.

__________________

barncobob

how about rhino ramps..not high enough...use any floor jack once its up on ramps....just thinking out loud here

ZCanadian

If you are not lowered, you can probably back onto Rhino ramps without scraping the front in order to work on exhaust. I'd have to try it to see if you can drive forward onto them OK, though. But you can't do both at once. Also, if you want to change wheels, work on brakes or suspension, or lift the car higher, you still need to jack the car and put it onto something. Hard to jack the car and put it on stands unless you can hoist from a location other than the authorized lift points and then install the jack stands on those. Sorry I'm not familiar enough with the Z to know if there is a central rear hoist point or can jack the entire side up, for instance.

madwi

Use the rear diff as the jack point.

Leingod

I always jack from the pumpkin in the back. Nipple from the front.

__________________
I AM FLOOF! SOMEBODY FLOOF MY HORN!! ALL HAIL THE FLOOF!!I JUST FLOOFED ON THE FLOOR

ZCanadian

Thanks!

We're still talking cars here, right?

madwi

have you viewed his GF? 3 ton floor jack is needed to get her up and moving towards the fridge. (J/k, she is good looking).