THE BULL

Hey, I just saw your post about the yaw sensor kit. What's the price for one of them? I'd be very interested in buying if you're still in production.

Nothing you do will get rid of this unfortunately. If you own anything with a VQ and drive it like it's meant to the oil temp WILL go up. Start looking for an oil cooler.

Nothing you do will get rid of this unfortunately. If you own anything with a VQ and drive it like it's meant to the oil temp WILL go up. Start looking for an oil cooler.

These gears with 2 added shims to the relief should be yielding higher cold start numbers. A contaminated relief should yield higher numbers. Lower numbers can be contributed to excess bearing...

These gears with 2 added shims to the relief should be yielding higher cold start numbers. A contaminated relief should yield higher numbers. Lower numbers can be contributed to excess bearing...

With the analog gauge what is the minimum pressure you see at cold start and for how long until you have to blip the throttle?

I did not need this reminder:icon14::bowrofl:

I did not need this reminder:icon14::bowrofl:

I did not need this reminder:icon14::bowrofl:

Well gallery gaskets should not need ANY RTV. I did coat my OEM new gaskets in really light RTV at the same time. Your best bet is to install a manual gauge or wire up the glowshift manually so it...

It's a lot of obsessiveness from my end and that not many folks go this route. After many dyno runs, tuners opinions and personal experience I feel like there's something to it. The Q50 is...

Well your idle with the AC on should be a bout the same with just about a 4-6% increase in load. On the contrary having the AC on will lower coolant temperatures a bit so this will affect the oil...

Small update: Kits have been put into production. Here's a sample of what they look like http://www.the370z.com/members/the-bull-albums-yaw-picture106533-resized-20220208-160151.jpeg ...

I have 3 of these clusters at the house and they sure are expensive. From taking them apart I can't see a passive way to install, almost 90% sure printing it would be the only option. What I do...

S mode is a challenge, You'd have to wire up the input shaft VSS sensor, Smode switch and possibly the rear diff since the auto will read a lower speed than what the input shaft sensor reads and even...

No need to drain anything, clean up whatever spills and you'll be good to go.