sandersd

Will that harnness work for 370z even though made for 350z? Also, will it work for both driver and passanger side? Thanks so much for your help.

Hey nice stable of cars! Just wondering what you think of the Nismo 370 compared to your 2002 996.. Which do you like more? Pros and Cons of each? I must say that I was looking at some used 996s before I bought my 370Z a couple years ago, never did I test drive one though.

First I determined where I would drill the holes. I knew I wanted the pins located in the flat area where the bumpers landed and I wanted to accurately place them symmetrically. Measuring was iffy...

As requested. Sorry it took so long. I work(ed) in the oil and gas industry which has tanked so I took a job in Florida. I moved to Ft. Myers in September and life is just now starting to take on a...

First I determined where I would drill the holes. I knew I wanted the pins located in the flat area where the bumpers landed and I wanted to accurately place them symmetrically. Measuring was iffy...

Saw this and knew it was exactly what I was looking for: 104568 Called Jtran for a quote but they said Seibon didn't make that hood anymore. Needless to say I was crushed. So I searched the...

Fly to Vegas to check out seats? That was kinda my point: a little inconvenient. Besides it's not open to the general public (http://www.semashow.com/the-sema-show) and only comes once a year.

Yes they are noisy. The reason they are noisy is because when installed positioned at the center of their travel they are quiet, but as soon as you drive they move to the edge of their travel and...

Before paint for those that prefer the all CF look: 111257 111258 After paint for the custom look: 111259

The washers were designed to snap into a square hole in the OEM 22ga sheetmetal hood but the cf of the Seibon was necessarily much thicker. The latches would not engage properly to hold the washers...

After the hood was painted I attached the seal with the provided pins. BTW I purchased an OEM replacement for the seal and the washers. I left the originals attached to the factory hood in case I...

I finished all the loose ends on my hood months ago but never posted the pics and descriptions so here they are for the record and the sake of completion: Prior to painting the hood I wanted to...

I tried bending the pin in an effort to align with the slot in the latch but as can be seen in the second pic even though it fit (sorta) in the slot the angle of the bend was the opposite of what it...

Slotted the second hole, bent and mounted the pin: 104667 104668 Here's the lip on the latch that has to be removed: 104669

From Aerocatch support: "I must advise that the aluminium pins must not be bent at all as doing so will lead to failure. You must make the fixing point of the pin suit the angle required or...

Now that the latches are finished it's time to adjust the pin height. Here's where the problem begins. Because of the curve of the hood the latches are at an angle relative to the pins. Compounding...

First I determined where I would drill the holes. I knew I wanted the pins located in the flat area where the bumpers landed and I wanted to accurately place them symmetrically. Measuring was iffy...