redondoaveb

Hey man, love your build! You've inspired me to build mine! I'm going to go for a Tomei with cat deletes and maybe some red JNC wheels like yours!

Hey brotha,

Currently installing the topgunz SC kit, and going the route of installing a external wastegate to help with in cabin boost control...Saw on one of the threads you went the same route...you happen to have a picture or explanation of this? just dont want to cut into the wrong piping if their is a better placement as its pretty tight in our bay with this kit

What size is your walbro fuel pump?

Hello, you said you followed me on Insta, what is your instagram?

Which Southbend Clutch are you running, and would you recommend it for a daily driver? I am ordering parts for my ACE Supercharger set up, and I am having a hard time with picking a clutch. I will be running e-85 and anticipate getting 420-460 rear wheel torque. I have a 10 mile daily commute in Chicago traffic.

Hey man, I finally received the switch. I have a question about your wiring. It's been a while since my electronics class so, bear with me. How did you wire up the switch to enable the halo light as well?

I'm guessing Common is connected to one end of the spliced Yaw Sensor Wire, and the other end is connected to Normally Closed. How did you wire up the halo light on the switch? Thanks for any help.

Disconnect the battery. Step on the brake pedal. This will relieve any current in the electrical system that maybe present. Reconnect the battery. If you have an Ecutek or UpRev tune. Disconnecting...

Sounds like a greedy tuner to me. Most of the good tuners would not have any problems making the quick change to turn off those sensors without additional cost.

Wz_DNrKVrQ8

LMAO, old man with sometimerz disease! Sent from my SM-G965U using Tapatalk

I believe that the stock 370z hood is aluminum, so it should not rust.

Isnt the hood Aluminum?

Dude is an idiot. When I heard him say cams are a waste, I stopped give that build attention.

Admin for the win. Sound like something admin would say. C2 cams are pointless

Good luck too him. That is all.

Where are they placed on this build?

Happy to report my temps have dropped about 20*. Took a drive in stop and go traffic it was about 100* out with about +65% humidity absolutely miserable and my water temps never went past 205*....

Closed deck block with apr 625 head studs. If the motor is properly put together and he doesn’t run it on kill mode on pump E I give it 3,500 miles before he start to push coolant

It’s administrative tuning. Come On

Sometimes the purpose of someone's life is to be an example of what not to do for others.

Well, this car is probably not making 900whp. This is STD with a correction factor of 1.09!! I have never seen such a high correction factor on a dyno.