redondoaveb

Hey man, love your build! You've inspired me to build mine! I'm going to go for a Tomei with cat deletes and maybe some red JNC wheels like yours!

Hey brotha,

Currently installing the topgunz SC kit, and going the route of installing a external wastegate to help with in cabin boost control...Saw on one of the threads you went the same route...you happen to have a picture or explanation of this? just dont want to cut into the wrong piping if their is a better placement as its pretty tight in our bay with this kit

What size is your walbro fuel pump?

Hello, you said you followed me on Insta, what is your instagram?

Which Southbend Clutch are you running, and would you recommend it for a daily driver? I am ordering parts for my ACE Supercharger set up, and I am having a hard time with picking a clutch. I will be running e-85 and anticipate getting 420-460 rear wheel torque. I have a 10 mile daily commute in Chicago traffic.

Hey man, I finally received the switch. I have a question about your wiring. It's been a while since my electronics class so, bear with me. How did you wire up the switch to enable the halo light as well?

I'm guessing Common is connected to one end of the spliced Yaw Sensor Wire, and the other end is connected to Normally Closed. How did you wire up the halo light on the switch? Thanks for any help.

http://www.the370z.com/members/zeeingaround-albums-funnies-picture101574-20is20.png

:iagree: Car covers are like anything else. You need to keep them clean as well as the car itself. When I use a cover, it gets shaken almost every time that I use it and would also get washed...

Keep in mind that whatever cover (if ) you decide on, the paint should be free of DUST & debris before installation. :twocents:

Frankly, I don't think it's a good idea to not use the vent plug provided by Vortech (my friend once did it due to mechanic mistake and ended up with tragedy. His Vortech Si even didn't survive for...

intake and throttle bodies back on. Tune from Seb waiting for me to download. :tup:

Fuel pump works. No leaks on the CJM return lines and fuel rails.

Lol will do man Ill have them up tomorrow, but you better come back and make this "worthy"

It will get done. Good machine shops are hard to come by and if they are OCD, everybody flocks to them. Is what it is. I will take a long wait over a "OH Crap the motor just popped", any day of the...

I bought my red haired Nismo Z in 2013. I honestly have to say this has been the best car that I ever owned. At almost six years I still get looks and talks from admirers at gas stations and car...

Well, thanks to Streetz (Justin) and Phunk, I am ordering the new Fast Intentions Stage 2.5 turbo's which are similar to Garrett GT3076r turbo's. The Xona Rotor turbo's will have a billet compressor...

I would trust the original manufacturer, Vortech, and not 928 and NOT risk it. Use a bit less SC oil as suggested and USE the vent plug.

Why would vortech go through the trouble and cost of having a machined plug replace an already installed plug if it serves no purpose?

CJM S1.SE fuel return installed with billet top hat. https://i.imgur.com/H1HIVzTl.jpg https://i.imgur.com/chVtyfil.jpg https://i.imgur.com/8BpbF7rl.jpg https://i.imgur.com/kUZ4Qzll.jpg

I agree. Something in writing would be amazing. Although mine seized up due to having sufficient oil to low enough to where it stopped working lol. Which means it consistently spilled out. How much...

https://i.imgur.com/fBawyugl.jpg