redondoaveb

Hey man, love your build! You've inspired me to build mine! I'm going to go for a Tomei with cat deletes and maybe some red JNC wheels like yours!

Hey brotha,

Currently installing the topgunz SC kit, and going the route of installing a external wastegate to help with in cabin boost control...Saw on one of the threads you went the same route...you happen to have a picture or explanation of this? just dont want to cut into the wrong piping if their is a better placement as its pretty tight in our bay with this kit

What size is your walbro fuel pump?

Hello, you said you followed me on Insta, what is your instagram?

Which Southbend Clutch are you running, and would you recommend it for a daily driver? I am ordering parts for my ACE Supercharger set up, and I am having a hard time with picking a clutch. I will be running e-85 and anticipate getting 420-460 rear wheel torque. I have a 10 mile daily commute in Chicago traffic.

Hey man, I finally received the switch. I have a question about your wiring. It's been a while since my electronics class so, bear with me. How did you wire up the switch to enable the halo light as well?

I'm guessing Common is connected to one end of the spliced Yaw Sensor Wire, and the other end is connected to Normally Closed. How did you wire up the halo light on the switch? Thanks for any help.

I installed Nismo (black) steering wheel controls today.

I installed Nismo (black) steering wheel controls today.

I installed Nismo (black) steering wheel controls today.

We're going to use a Greddy Profec.

I talked to Seb (Specialty Z) about your concern and as he hasn't done it on a 370z yet, he has done it on a mustang with success. He'll be doing my re-tune once my mechanic gets it installed. He's...

As posted above "you get what you pay for". For me, to not have to do anything except drop the car off and pick it up when done and I've seen the quality of the shops work, $200.00 isn't bad at all.

Here's what mine looked like with stock sport rays, 20mm bolt on spacers (4 corners) and lowered 1". No rubbing at all.

On my sc wastegate, we're going to install an 8lb spring and then control boost dump with a Greddy Profec.

:iagree:

I already have the spacer from 928, thanks for the info on it needing to be 3/8" and the bolt length, good info. I was going to use washers on the idler pulley.

The Si impeller is an upgrade from the Sci. The 928 is a billet impeller and according to them it's an upgrade to both the Sci and Si.

Just trying to help out a fellow geezer. :tiphat:

Try using more Poligrip. :rofl2:

Try using more Poligrip. :rofl2:

For the little bit of money you spend, you have peace of mind. I have the 9lb pulley and the 2.85 sc pulley. There is no reason for the car to not be reliable, it drives like a stock car. It drives...