Nissan 370Z Forum - View Profile: KapitalZ

KapitalZ liked post by Spooler On thread : SPC vs SPL for Track and Weekend Driver

Get the SPL, you will thank everyone later.

Liked On: 07-25-2019, 06:41 AM
Posted On: 08-21-2016, 09:29 PM

KapitalZ liked post by Rusty On thread : SPC vs SPL for Track and Weekend Driver

My Nismo is all SPL. I track mine alot. Had the front upper control arms and lower bushings on for 3 years now. No increase in noise when installed. The SPL upper arms are the easiest to adjust.

Liked On: 07-25-2019, 06:41 AM
Posted On: 08-21-2016, 07:06 PM

KapitalZ liked post by Rusty On thread : The Complete SPL Rear Suspension (Almost)

Every suspension pivot point now has a SPL bushing in place of the stock rubber ones. :tup:

Liked On: 07-25-2019, 06:39 AM
Posted On: 02-15-2019, 10:20 PM

KapitalZ liked post by Brendan On thread : 18's on a 370z

Finally have something to contribute. Volk ZE40 18x10.5 +24 front 18x10.5 +15 rear 275/40r18 https://live.staticflickr.com/65535/48562566136_ce4f13a9ff_c.jpg...

Liked On: 07-24-2019, 03:31 AM
Posted On: 07-23-2019, 08:37 AM

KapitalZ liked post by Hotrodz On thread : Oil Cooler - Is it really necessary?

You did good...right year, right color...wrong transmission!:stirthepot:

Liked On: 07-15-2019, 09:46 PM
Posted On: 01-17-2018, 07:47 AM

KapitalZ liked post by Rusty On thread : Oil Cooler - Is it really necessary?

OP, if you see temps in the 240's. Get an oil oil cooler. The ECU will start to pull timing at 240F. And go into limp mode at 280F. Get a 25 row. If you want to push it. :driving: Get a 34 row. ...

Liked On: 07-15-2019, 09:27 PM
Posted On: 01-10-2018, 11:27 PM

KapitalZ liked post by Eagle On thread : Oil Cooler - Is it really necessary?

On a 90 degree day here in California, your car will probably be at 200 just sitting at idle. One highway pull will probably push your temps closer to 220. In traffic and warm weather i've seen temps...

Liked On: 07-15-2019, 09:10 PM
Posted On: 01-09-2018, 04:25 PM

KapitalZ liked post by JARblue On thread : oil cooler necessary ?

Absolutely you will need an oil cooler. Unless you are planning for a short track session. After three laps at COTA, my 2011 had oil temps over 250F. After a 15 min break and then three more...

Liked On: 07-15-2019, 09:00 PM
Posted On: 05-07-2014, 10:14 AM

KapitalZ liked post by pbs370z On thread : Which oil cooler is the best?

I like my Z1 Motorsports Setrab 25 row with Mocal t-stat adapter plate. You dont need a 34 row cooler unless youre crankin out boosted horsepower and racing. My opinion only. With this setup I...

Liked On: 07-15-2019, 07:34 AM
Posted On: 06-13-2015, 05:15 PM

KapitalZ liked post by XwChriswX On thread : Front Strut tower brace options???

Here's mine, Powder Coated to match the wheels: http://www.the370z.com/attachment.php?attachmentid=59505&stc=1&d=1355899097 ...

Liked On: 07-02-2019, 04:02 AM
Posted On: 12-19-2012, 12:39 AM

KapitalZ liked post by labrador On thread : 370Z oil cooler necessary?

South Texas here, like mexican border south, I have a 144 mile roundtrip to work. No oil cooler, I stay around 220-230 in these hot *** months. Been doing it for 7 years now since the car was new. ...

Liked On: 06-30-2019, 08:01 PM
Posted On: 08-10-2016, 10:37 PM

KapitalZ liked post by A66auto On thread : 370Z oil cooler necessary?

I live and drive a 2012 in the foothills of California. I see over 220 during spirited driving in the summer. I see 220 in stop and go traffic when it is 100+. I will be getting an oil cooler. I...

Liked On: 06-30-2019, 07:58 PM
Posted On: 08-10-2016, 01:00 PM

KapitalZ liked post by ZeeBabar On thread : 370Z oil cooler necessary?

A lot if it is bull. If you do not race or track, there is no need for an oil cooler. I don't race or track. On the highway, I do take a 500 mile week end trip almost every week, I consistently...

Liked On: 06-30-2019, 07:56 PM
Posted On: 08-10-2016, 10:15 AM

KapitalZ liked post by Rusty On thread : Bell Raceworks Diff Brace Install

Clearance issues. :mad:

Liked On: 06-24-2019, 04:09 AM
Posted On: 01-30-2019, 07:11 PM

KapitalZ liked post by Rusty On thread : Bell Raceworks Diff Brace Install

Installing the Raceworks Diff Brace from Z1. Save your money. It's bad. I tried installing mine tonight. If you have exhaust like FI. You have to trim about 1 3/8" off of the corner of the brace...

Liked On: 06-24-2019, 04:09 AM
Posted On: 01-30-2019, 07:06 PM

KapitalZ

Base Member

Statistics

Likes Given

Mini Statistics