DarkJak

Good morning. I’m in the process of finishing my build and I’m leaning toward using the rear o2 for ecutek input. Would you mind if I ask you a question? My Ig is @reynaldoski

Hi Ed, when you have a chance, I just need your closest Greyhound center for a shipping quote. Thanks

Hi Ed, I tried to send you a message but it says your mailbox is full.

he probably flew away bc lack of downforce

Almost three ours went by. I hope you still OK?

Looking to finally part ways with my exhaust off of my 370. This is the official RC exhaust off of the Nissan factory made Nismo race car that raced in the US. The exhaust is a single sided exhaust...

That sounds awesome! I know Seb has received a bunch of inquiries since he last posted Instagram. He has received over 3400 views on his last post of his test drive. Check it out if you get a chance!...

Hey phunk! I know you got a lot of irons in the fire but you need to get this conversion kit going like yesterday. I got to take a ride with Seb a week ago and all I can say is holy crap. It was...

Thanks for the push! I definitely lost some of my momentum on the project while waiting for final install and testing and then started putting my energy into other places. The other day Seb was...

So after doing some research and actually seeing the wing in person and seeing how it performs on track pulled the trigger and ordered. I installed it 2 weeks right before my first track day of the...

Hello, [SOLD] I'm selling a used Z1 fuel anti starvation kit used for less than 1000 miles for $350 (never installed myself). I bought the kit from another forum user and no longer need it. ...

...

And the test car is back on the road! It’s going good. I just received a couple vids of him going through a few gears in low boost taking it a little easy. Im leaning into him for some more spicy...

I read every single update on this build. Looking forward to more action :-) Sent from my SM-G973F using Tapatalk

:leghump:

Welp, he has already removed the trans, located the wiring short, and repaired it. He plans to put the trans back in and be back on the road for more testing this week. He’s just letting it sit a day...

a 7AT would use the same driveshaft since it has the same differential case and pinion flange. The only thing that may be different about the 7AT car install is going to be on the electronics side....

You might have boiled the diff lube. It's been known to happened. It smells ready bad. It goes out the vent tube and lays in the rear sub-frame. If it came out of the tranny vent tube. You could...