BBRSpeedWorks

Let me know when it will be available

So this may be a stupid question but I was curious if I could slowly start buying the pieces Im gonna need to start putting a system together not sure if u do that kind of thing just curious

No I won't be able to I starting a build for 370z twin turbo kit on a buddy's car

Thanks you wil be the first one I hollar at ! By the way are u gonna be at nationals this year !

First let me thankyou for your service ! THANK YOU !!!
I read ur build and was very impressed with what you did great work ! I am considering going FI the first of the year and I'm sure I will have tons of questions ! Hope you want mind but u seem like someone who wouldn't mind helping out unlike some others who maybe concerned with theirselves! Thanks

Just got off the phone with bryan and we are set for tomorrow. All heat cycles went well and he plans on disconnecting the exhaust to see if my existing is bottlenecking while on the dyno.. May need...

No s h I t right, lmao!!!!!!:bowrofl::bowrofl::bowrofl::bowrofl::bowrofl:

I was going to bet that you throw the rod in cylinder 5 before you reach 600 hp :stirthepot: But then I remembered Bryan is doing the work, not Bobby :icon17: Good luck with your numbers...

*.4 Mach is the point at which air becomes turbulent and losses in efficiency start to occur exponentially. The key is to stay under that speed. You want to use the smallest piping possible that...

Just wanted to add in order to convert from Lb/Min to CFM for the equation above, you take the flow rate in Lb/Min for your turbo (generally an educated guess based on the pressure ratio and power...

Here are the 3" lower charge pipes I had bryan make for me to allow my 6466 to breathe..

One of the issues was my new clutch over extending because joe from zspeed didn't exactly know what size bushing to send. The next thing was having to get bryan to make new lower charge pipes because...

I agree with you on the ignorant f@ck but I really don't want this thread shut down due to some tool who has actually spent an exuberant of money for his alter ego.. Would love to see your build and...

Going to stick with os giken twin disk for now but thanks... Can't wait to get my baby back..

The update she is still slow lol... Going to share those new meat flaps with the mere mortals? Hehe

Here is a pic of my new block about to be assembled ..

Check it out, bryan hard at work.... https://www.facebook.com/BBRSpeedworks

Just got word my engine bore and acid dip is Done!!!! Stay tuned for pics.. Had my injectors sent to FIC to be checked and cleaned and they checked out just fine. Bobby even tried to say the reason...

Also forgot to mention everything balanced and cranked polished by bryan.. Going to go ahead and order new rings and bearings before the assembly..

CP 10.1, 96mm pistons.. Compliments from bryan..