370zHawaii

Greetings. Some of your activity goes way back. Hope you are still there. I am looking for a 370Z specialty shop, or someone who is very familiar with 370's. On my 2019 370Z, I want to have installed and oil cooler, cold air intake, performance exhaust, etc. probably a chip and dyno. Is this you? Can you tell me any such shops between Orlando and Ft Lauderdale?

Sorry, they only make this part in "Men's" :( Better luck next time! (jk, my troll instinct couldn't be denied - but I believe this is still MT only)

That doesn't sound right. I would try again. Make sure you take it in 3 times in a month or so. No action then, I would get an attorney and lemon it.

What kind of rust? If it's just on the surface (similar to a patina), it's not a big deal. Every car I've owned had some surface rust somewhere; steel frames are covered with it. Sand, prime, and...

Might as well post here now too

https://www.yuniqueled.com/ Have Z headlight build sheet right on their site so you can see the cost for your chosen options immediately.

So close to $40k OTD for a used 2016 Nismo Tech with 40 THOUSAND MILES!!!???!!! I see that it's a 2015 build date, so reasonable mileage, but the price? C'MON SON! No. I don't care if you're in...

Hey All, So I dropped off my 2017 Nismo today at Fever Racing here in Tampa and Martin tuned it on a Dyno-Jet with the UpRev Software. Wow, what a difference over stock. For those of you who are...

Agreed it’s subjective but the Nismo Sentra is the best Nismo ever! Until the Nismo leaf released then that trumps all. I hope Nissan would do a Nismo Quest, that for sure going to be extra special....

Almost finished gathering everything! I am waiting on intercooler piping & turbo fittings before I put the car in the air. ...

I had my Stillen Lightweight Pulley installed this morning and the shop I go to maintains a '72 240z for a local Doctor, which happened to be there this morning as well. So I did an impromptu...

its an oldass thread that you bumped

https://i.imgur.com/pomDV3V.jpg?2

I run Z1 two piece rotors and so far they worn very well. The unsung weight is very noticeable up front. It makes for better turn it as effort is decreased. I don't think rears are as big a deal but...

Any updates?

http://uploads.tapatalk-cdn.com/20161129/637d627e1fce1fcbab2abda56fb1f017.jpghttp://uploads.tapatalk-cdn.com/20161129/8fb3e56979174b5455395db4c2e7e5f9.jpghttp://uploads.tapatalk-cdn.com/20161129/873f7...