YzGyz's turn!

YzGyz · 01-16-2015, 04:28 PM

Hi Hi Rooftop. Hows the air up there?

As for the bold, nut, screw thing, Both of those ways are nice. I have a mag plate myself but I always seem to forget where things go unless I put it within relative close proximity of it. I only do this on big jobs. My memory is bad but not that bad. IDK, I have been doing it this way for a while and it work for me.

I do have a question for you guys with a boost controller. I might post a new thread in the other forum but maybe not. Anyhoo, I'm at a lost as to where to put the sensor for the boost-controller. This bung or whatever you call it needs to get welded on to the pipes somewhere. It would not be a problem if I was to leave the pipes unwrapped but I'm going to wrap them. Basically, I need to know how/where are you guys getting the bung thingy welded on at so I can get it welded (it's suppose to be angled from top down to reduce chances of early failure) so I can then wrap the pipe.

YzGyz

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turn knob and A/C turns on. Can i turn it off?	zmyride	Nissan 370Z Owners Manual / Service Manuals	18	04-24-2015 01:17 PM
Turn down for what	RoadsterST	Movies / Celebrity Gossip / Entertainment / Music	2	03-28-2014 03:43 PM
My turn	RITDR	Audio & Video	4	05-19-2013 06:49 PM
My turn!!!	alvinmathew88	Nissan 370Z Pricing / Ordering Discussions	14	02-03-2011 06:44 PM
First Turn-by-Turn Navigation App for iPhone: XROADS G-Map Review	AK370Z	The Lounge (Off Topic)	5	12-12-2009 12:33 AM

01-16-2015, 04:28 PM	#11 (permalink)
YzGyz A True Z Fanatic Join Date: Jun 2013 Location: Houston Posts: 1,449 Drives: 2010 Nismo Rep Power: 65	Hi Hi Rooftop. Hows the air up there? As for the bold, nut, screw thing, Both of those ways are nice. I have a mag plate myself but I always seem to forget where things go unless I put it within relative close proximity of it. I only do this on big jobs. My memory is bad but not that bad. IDK, I have been doing it this way for a while and it work for me. I do have a question for you guys with a boost controller. I might post a new thread in the other forum but maybe not. Anyhoo, I'm at a lost as to where to put the sensor for the boost-controller. This bung or whatever you call it needs to get welded on to the pipes somewhere. It would not be a problem if I was to leave the pipes unwrapped but I'm going to wrap them. Basically, I need to know how/where are you guys getting the bung thingy welded on at so I can get it welded (it's suppose to be angled from top down to reduce chances of early failure) so I can then wrap the pipe. YzGyz