|
I installed the Z1 hood struts today. The only problem was on one of the struts the C clip inside of the cup was stopping the ball from fully going
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
01-22-2013, 07:48 PM
|
#11 (permalink) |
|
A True Z Fanatic
 
Join Date: Aug 2011
Location: Ontario, Canada
Posts: 21,749
Drives: Varis Arising II
Rep Power: 51866   |
Z1 hood struts
I installed the Z1 hood struts today. The only problem was on one of the struts the C clip inside of the cup was stopping the ball from fully going in. As a result I couldn't insert the locking clip. The fix was to take a small flat screwdriver and rotate the C clip until it was sitting in such a way that the ball could be fully inserted.
As far as the "hood bulge" issue, I studied my hood prior to the install and noticed the driver side sits higher than the passenger side. This was consistent for the length of the hood. I did not notice a change after the hood was installed.  IMG_2672 by J M Gale, on Flickr
__________________
 |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| My Z Build | pwrhsms | Member's 370Z Gallery | 43 | 09-09-2013 11:35 AM |
| Possible Nos build | triadz | Forced Induction | 7 | 04-06-2012 10:30 AM |
| TT build in Fl | travnflorida | Nissan 370Z General Discussions | 3 | 08-15-2011 05:51 PM |
| THE "Lets argue about Bullitt's build with out ruining Bullitt's build thread" THREAD | Reaper42 | Forced Induction | 14 | 01-22-2011 05:24 PM |
| Datsun Roadster 1600...To build or not to build | motoextreme | The Lounge (Off Topic) | 66 | 02-13-2010 12:40 AM |
5798Likes
Threaded Mode
